All Products

SKU: AF-3346 | Brand: Adafruit

The Adafruit I2S 3W Stereo Speaker Bonnet adds high-quality digital audio output to any Raspberry Pi with a 2×20 GPIO header. Using the I2S digital sound standard, audio data goes directly to the onboard Class D ampli...

SKU: AF-5764 | Brand: Adafruit

The Adafruit TRRS Jack Breakout Board provides easy access to all four contacts of a 3.5mm TRRS (Tip-Ring-Ring-Sleeve) audio jack — commonly used for stereo audio plus a microphone channel, as found on mobile phone he...

SKU: AF-5134 | Brand: Adafruit

THE REACTOR'S MELTING DOWN! GRAB THE FUEL CORE, JENNA, AND EVACUATE THE COMMAND CENTER! With this Rotating LED Warning Light with Adjustable Volume Buzzer Alarm, you can monitor and easily alert humanoids as to the st...

SKU: AF-3492 | Brand: Adafruit

The Adafruit PDM MEMS Microphone Breakout provides a digital audio input using Pulse Density Modulation (PDM) — a common interface in commercial products that's distinct from both analogue and I2S microphones. It's id...

SKU: AF-6251 | Brand: Adafruit

The Adafruit PCM5100 I2S DAC converts digital I2S audio into clean, high-quality stereo line-level output through a 3.5mm jack. With 100dB signal-to-noise ratio and no MCLK or I2C configuration required, simply pipe I...

SKU: AF-5647 | Brand: Adafruit

The Adafruit STEMMA Audio Amp is a compact mono Class D amplifier based on the PAM8302 chip, delivering up to 2.5W into 4 Ω speakers from a 2.0–5.5V DC supply. With over 90% efficiency at half a watt into 8 Ω, it's id...

SKU: AF-5770 | Brand: Adafruit

The Adafruit I2S Amplifier BFF is a compact add-on that brings high-quality 3W audio to any QT Py or Xiao development board. Featuring a MAX98357 Class D amplifier, it delivers crisp I2S digital audio using just three...

SKU: AF-1732 | Brand: Adafruit

A high-power 4" (102mm) full-range speaker rated at 20W continuous with 4Ω impedance. The wide frequency response of 60Hz–24kHz delivers clear audio across the full spectrum, making it suitable for projects where you ...

SKU: AF-1790 | Brand: Adafruit

The Adafruit Music Maker MP3 Shield turns any Arduino into a versatile audio player, recorder, and MIDI synthesiser. Powered by the VS1053B codec chip, it decodes MP3, AAC, Ogg Vorbis, WMA, FLAC, WAV, and MIDI formats...

SKU: AF-2210 | Brand: Adafruit

The Adafruit Audio FX Sound Board with 2×2W Amp is a standalone audio trigger with a built-in stereo Class D amplifier — no Arduino or programming required. Simply drag and drop WAV or OGG sound files over USB, wire u...

SKU: AF-2915 | Brand: Adafruit

A 3.5 mm (1/8") 4-pole TRRS audio jack with screw terminal connections — no soldering required. Use stranded or solid-core wire and a small screwdriver to create custom audio wiring jigs, breakouts, and test setups. ...

SKU: AF-4445 | Brand: Adafruit

A compact 2.8" × 1.2" enclosed mono speaker delivering clear audio output at 3W and 4 ohm impedance. The sealed enclosure provides improved sound quality and volume compared to bare speaker drivers of a similar size. ...

SKU: AF-4227 | Brand: Adafruit

Hear the good news! This wee speaker is a great addition to any audio project where you need 8 ohm impedance and 1W or less of power. We particularly like this speaker as it is small and comes with nice skinny wires w...

SKU: AF-1759 | Brand: Adafruit

Mod your stuffed toy to chirp, meow, or woof! This GEMMA parts pack makes it easy to add simple sounds to any plush toy, and especially the Sew-Your-Own Owl Kit (not included!) A tilt ball switch is used to trigger...

SKU: AF-2716 | Brand: Adafruit

The Adafruit SPW2430 Silicon MEMS Microphone Breakout is a compact, low-cost microphone module that detects sound and converts it to an analog voltage — no external bias resistor or amplifier needed. With a frequency ...

SKU: AF-5986 | Brand: Adafruit

This compact enclosed mono speaker delivers clear audio at up to 1 W with 8 Ω impedance. The sealed enclosure provides better volume and sound quality compared to bare speaker drivers of a similar size, making it a pr...

SKU: AF-3885 | Brand: Adafruit

The Adafruit STEMMA Speaker combines a Class D audio amplifier with a 1W 8 Ω speaker in one slim, portable package. Connect ground, 3–5V power, and an audio signal via the JST-PH STEMMA connector or the alligator/sew-...

SKU: AF-2133 | Brand: Adafruit

The Adafruit Audio FX Sound Board is a standalone audio trigger that plays WAV and OGG Vorbis files — no Arduino or programming required. Simply drag and drop sound files over USB, wire up buttons to the trigger pins,...

SKU: AF-3357 | Brand: Adafruit

The Adafruit Music Maker FeatherWing turns any Feather board into a versatile audio player and MIDI synthesiser. Powered by the VS1053B codec chip, it decodes MP3, AAC, Ogg Vorbis, WMA, FLAC, WAV, and MIDI formats, wi...

SKU: AF-3436 | Brand: Adafruit

The Adafruit Music Maker FeatherWing with Amplifier brings powerful audio playback to any Feather board. Built around the VS1053B codec chip, it decodes a wide variety of formats including MP3, AAC, Ogg Vorbis, WMA, M...