All Products

SKU: AF-3421 | Brand: Adafruit

The Adafruit I2S MEMS Microphone Breakout features the SPH0645LM4H, a tiny digital MEMS microphone with a purely digital I2S output. Unlike analogue electret microphones, this mic sends digital audio data directly to ...

SKU: AF-3367 | Brand: Adafruit

The Mini USB Microphone is an ultra-compact plug-and-play USB microphone that requires no drivers. Simply plug it into any USB port and start recording immediately. Compatible with Raspberry Pi, laptops, desktops, an...

SKU: AF-3006 | Brand: Adafruit

The Adafruit MAX98357A I2S Class D Amplifier Breakout is an all-in-one digital audio solution that decodes I2S audio and amplifies it directly to a speaker — no separate DAC required. Delivering up to 3.2W into a 4Ω s...

SKU: AF-1713 | Brand: Adafruit

Add an ear to your project with this well-designed electret microphone amplifier with AGC. This fully assembled and tested board comes with a 20-20KHz electret microphone soldered on. For the amplification, we use th...

SKU: AF-1063 | Brand: Adafruit

A well-designed electret microphone amplifier breakout built around the Maxim MAX4466 op-amp, specifically engineered for microphone amplification with excellent power supply noise rejection. The board comes fully ass...

SKU: AF-2342 | Brand: Adafruit

The Adafruit Audio FX Mini Sound Board is a standalone audio trigger that plays WAV and OGG Vorbis files — no Arduino or programming required. Simply drag and drop sound files over USB, wire up buttons to the trigger ...

SKU: AF-5791 | Brand: Adafruit

The Adafruit STEMMA Piezo Driver Amp uses the PAM8904 switched-capacitor driver to amplify signals for piezo elements at up to 300 kHz. With bridge-tied load (BTL) output and up to 3× voltage multiplication, it can de...

SKU: AF-5764 | Brand: Adafruit

The Adafruit TRRS Jack Breakout Board provides easy access to all four contacts of a 3.5mm TRRS (Tip-Ring-Ring-Sleeve) audio jack — commonly used for stereo audio plus a microphone channel, as found on mobile phone he...

SKU: AF-3492 | Brand: Adafruit

The Adafruit PDM MEMS Microphone Breakout provides a digital audio input using Pulse Density Modulation (PDM) — a common interface in commercial products that's distinct from both analogue and I2S microphones. It's id...

SKU: AF-6251 | Brand: Adafruit

The Adafruit PCM5100 I2S DAC converts digital I2S audio into clean, high-quality stereo line-level output through a 3.5mm jack. With 100dB signal-to-noise ratio and no MCLK or I2C configuration required, simply pipe I...

SKU: AF-2716 | Brand: Adafruit

The Adafruit SPW2430 Silicon MEMS Microphone Breakout is a compact, low-cost microphone module that detects sound and converts it to an analog voltage — no external bias resistor or amplifier needed. With a frequency ...

SKU: AF-3885 | Brand: Adafruit

The Adafruit STEMMA Speaker combines a Class D audio amplifier with a 1W 8 Ω speaker in one slim, portable package. Connect ground, 3–5V power, and an audio signal via the JST-PH STEMMA connector or the alligator/sew-...

SKU: AF-5769 | Brand: Adafruit

The Adafruit Audio BFF is a compact add-on board that turns your QT Py or Xiao into a powerful audio playback device. It features a microSD card slot (up to 64 GB) and a MAX98357 I2S 3W amplifier, all designed to fit ...

SKU: AF-4346 | Brand: Adafruit

The Adafruit PDM Microphone Breakout with JST SH Connector provides a digital audio input using Pulse Density Modulation (PDM) in a compact, cable-ready form factor. The 4-pin JST SH connector (3V, GND, DAT, CLK) pair...

SKU: AF-3678 | Brand: Adafruit

The Adafruit UDA1334A I2S Stereo DAC Breakout converts digital I2S audio into clean stereo analogue line-level output. Built around the NXP UDA1334A, this versatile DAC supports 3.3V and 5V logic levels and works with...

SKU: AF-6250 | Brand: Adafruit

The Adafruit PCM5102 I2S DAC converts digital I2S audio into excellent stereo line-level output through a 3.5mm jack. With an impressive 112dB signal-to-noise ratio and no MCLK or I2C configuration required, simply pi...