All Products

SKU: LB-FLAME-LIGHT | Brand: Little Bird

This IR flame sensor module detects flames and infrared light sources in the 760–1,100 nm wavelength range. With a detection angle of approximately 60° and a test range of up to 80 cm (depending on flame size), it pro...

SKU: DF-DFR0654 | Brand: DFRobot

The FireBeetle Board ESP32-E is a compact IoT development board based on the ESP-WROOM-32E module with a Tensilica LX6 dual-core processor running at 240MHz. It supports Wi-Fi 802.11 b/g/n and Bluetooth 4.2 (BR/EDR + ...

SKU: LB-LR0007 | Brand: Little Bird

Flame Detection Sensor Module for use with Arduino Sensor for flame wavelengths between 760 nm to 1100 nm infrared is most sensitive60 degree detection sensor   Two outputs mode: AO: analog output, real-time ou...

SKU: DF-DFR0718 | Brand: DFRobot

This is a compact and cost-effective Bluetooth 5.0 audio receiver module that supports automatic reconnect function. It can be powered by a micro USB or 3.7V lithium battery. You can easily convert your old speaker...

SKU: DF-DFR0720 | Brand: DFRobot

This is a small size and cost-effective Bluetooth 4.2 Audio Receiver module with dual 5W power amplifier circuits. It supports auto-reconnect and can be powered by micro USB or 3.7V lithium battery. The module can be ...

SKU: DF-DFR1096 | Brand: DFRobot

The Arduino Nano ESP32 brings the ESP32-S3 (u-blox NORA-W106 module) into the familiar Nano form factor with a USB-C connector. It supports both Arduino and MicroPython programming, making it an accessible entry point...

SKU: AF-1085 | Brand: Adafruit

Add precision analog-to-digital conversion to any microcontroller with the ADS1115 breakout. This 16-bit ADC delivers 860 samples per second over I2C, with four single-ended or two differential input channels and a bu...

SKU: AF-1713 | Brand: Adafruit

Add an ear to your project with this well-designed electret microphone amplifier with AGC. This fully assembled and tested board comes with a 20-20KHz electret microphone soldered on. For the amplification, we use th...

SKU: SF-SEN-15901 | Brand: SparkFun

This Weather Meter Kit provides the three core sensors for a DIY weather station: an anemometer (wind speed), a wind vane (wind direction), and a rain gauge. All three sensors use passive magnetic reed switches rather...

SKU: AF-1063 | Brand: Adafruit

A well-designed electret microphone amplifier breakout built around the Maxim MAX4466 op-amp, specifically engineered for microphone amplification with excellent power supply noise rejection. The board comes fully ass...

SKU: AF-2831 | Brand: Adafruit

This Photo Transistor Light Sensor is a simple sensor that detects ambient light. It's kind of the opposite of an LED - when light hits the little chip inside, it induces current to flow from the long pin...

SKU: AF-3405 | Brand: Adafruit

The Adafruit HUZZAH32 ESP32 Feather Board brings the powerful Espressif ESP32 dual-core processor into the Adafruit Feather form factor. With WiFi, Bluetooth Classic, and BLE support, a built-in USB-to-serial converte...

SKU: DF-DFR0868 | Brand: DFRobot

The Beetle ESP32-C3 is a coin-sized IoT development board based on the ESP32-C3 RISC-V 32-bit single-core processor. Measuring just 25 × 20.5 mm, it breaks out up to 13 GPIO pins and integrates lithium battery chargin...

SKU: DF-SEN0206 | Brand: DFRobot

INTRODUCTION We can divide temperature measurement in to two types: contact and non-contact. Contact measurement can only accurately measure temperature when the testing object and the se...

SKU: SF-SEN-09375 | Brand: SparkFun

This is a force sensitive resistor with a round, 0.5" diameter, sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the ...

SKU: AF-5791 | Brand: Adafruit

The Adafruit STEMMA Piezo Driver Amp uses the PAM8904 switched-capacitor driver to amplify signals for piezo elements at up to 300 kHz. With bridge-tied load (BTL) output and up to 3× voltage multiplication, it can de...

SKU: DF-DFR0762 | Brand: DFRobot

Specially designed for FireBeetle 2 series (M0, ESP32-E), this Gravity IO expansion shield offers various ports including digital, analog, I2C, UART, SPI, etc. Also, it comes with power input socket for connecting ext...

SKU: EC-WCW32110W | Brand: Elecrow

The ESP-WROOM-32 is Espressif's powerful Wi-Fi, Bluetooth Classic, and BLE module built around the ESP32 dual-core processor. It's a versatile platform for IoT applications ranging from low-power sensor networks to de...

SKU: AF-161 | Brand: Adafruit

CdS cells are little light sensors. As the squiggly face is exposed to more light, the resistance goes down. When its light, the resistance is about 5-10KΩ, when dark it goes up to 200KΩ. To use, connect one side o...

SKU: DF-DFR0896 | Brand: DFRobot

The ESP32-S3-WROOM-1-N4 is a powerful Wi-Fi and Bluetooth LE MCU module built around the ESP32-S3 SoC. Featuring a dual-core Xtensa LX7 processor running at up to 240MHz, 4MB SPI flash, and hardware acceleration for n...