All Products

SKU: LB-LR0298 | Brand: Little Bird

This stand alone DHT11 can read the temperature and humidity and send the information over a one wire, simplex serial bus. Arduino.cc provides a DHT11 library to aid in communicating with this module.**DHT11 Temper...

SKU: AF-4890 | Brand: Adafruit

Need to measure something with a very slim sensor? This precision 10K thermistor is an inexpensive way to measure temperature in a small gap, or taped to a flat surface, it's only 0.2mm wide!The resistance in 25°C is ...

SKU: AF-158 | Brand: Adafruit

Hall effect sensors detect whether a magnet is near. Useful for non-contact/waterproof type switches, position sensors, rotary/shaft encoders. I tried dozens of different hall effect sensors to see which one wou...

SKU: SF-SEN-10266 | Brand: SparkFun

Use this simple IR receiver for infrared remote control of your next project. With low power consumption and an easy to use package, it mates well with embedded electronics and can be used with common IR remotes. The...

SKU: SF-COM-16473 | Brand: SparkFun

The classic 555 timer/oscillator IC from Texas Instruments — one of the most versatile and widely used integrated circuits in electronics. With just a few external resistors and capacitors, it can generate timing dela...

SKU: AF-161 | Brand: Adafruit

CdS cells are little light sensors. As the squiggly face is exposed to more light, the resistance goes down. When its light, the resistance is about 5-10KΩ, when dark it goes up to 200KΩ. To use, connect one side o...

SKU: AF-3930 | Brand: Adafruit

This Reflective IR Sensor is a simple plastic casing with two elements - an IR LED and an IR phototransistor. You can control the IR LED and turn it on to bounce IR off objects to determine their reflectivity. Whit...

SKU: AF-157 | Brand: Adafruit

IR sensor tuned to 38KHz, perfect for receiving commands from a TV remote control. Runs at 3V to 5V so it's great for any microcontroller.To use, connect pin 3 (all the way to the right) to 5V power, pin 2 (middle) to...

SKU: AF-4489 | Brand: Adafruit

Run two solenoids, or a single DC motor with up to 800mA per channel using the super-simple L9110H H-bridge driver. This bridge chip is an 8 DIP package so it's easy to fit onto any breadboard or perfboard.Each chip c...

SKU: DF-FIT0180 | Brand: DFRobot

This type of photoresistor is made of environment-friendly materials(no Cadmium and Lead) compared with the traditional CDS photoresistor. It changes resistance depending on the amount of light it is exposed to. Thes...

SKU: SF-COM-00299 | Brand: SparkFun

The Texas Instruments CD74HC4067 is a 16-channel analogue multiplexer/demultiplexer IC. It allows you to route one of 16 analogue signals to a single common pin (or vice versa) using just 4 digital control lines plus ...

SKU: SF-COM-15809 | Brand: SparkFun

The W25Q32FV (32M-bit) Serial Flash memory provides a storage solution for systems with limited space, pins, and power. This small SMD IC series offers flexibility and performance well beyond ordinary Serial Flash dev...

SKU: SF-COM-18076 | Brand: SparkFun

The GD25Q40C is a 4 Mbit (512 KB) serial flash memory chip supporting standard, dual, and quad SPI interfaces. With clock speeds up to 120 MHz and quad I/O transfer rates reaching 480 Mbits/s, it provides fast non-vol...

SKU: AF-4763 | Brand: Adafruit

These little chips are like miniature SSD drives for your electronics. When you don't need something with as much storage as a micro SD card, but an EEPROM is too small, SPI (or QSPI) Flash chips give you on-the-order...

SKU: AF-3877 | Brand: Adafruit

A hex Schmitt-trigger inverter IC that doubles as a handy logic level shifter. The 74AHCT14 provides six independent inverter channels, each with Schmitt-trigger inputs for clean switching on noisy or slow-transitioni...

SKU: SF-COM-10953 | Brand: SparkFun

The MMA8452Q is a low-power, 3-axis capacitive MEMS accelerometer with 12-bit resolution. Packed with embedded motion-detection functions and configurable interrupt outputs, it can monitor events autonomously while st...

SKU: SF-SEN-09602 | Brand: SparkFun

The MPL115A1 is a digital barometer that uses MEMs technology to give accurate pressure measurements between 50kPa and 115kPa. We stock the SPI interface version of the sensor. Average current consumption is 10µA at o...

SKU: PI-COM0212 | Brand: Pimoroni

Take control of your voltage! These regulators will let you produce a reliable constant supply voltage for your circuits. Whether you're working from an unregulated supply or just need a precise voltage for your micro...