All Products

SKU: EC-CIA51002C | Brand: Elecrow

W5100 is a multifunctional Monolithic network interface chip, internal integrate a 10/100 Ethernet controller , it apply to a embedded system which is High-Integrate, high-stability, high-performance but low-cost. By ...

SKU: DF-FIT0668 | Brand: DFRobot

A versatile 2-in-1 USB cable with both USB-C and Micro USB connectors on one end, so you can charge and program devices with either interface using a single cable. The flat cable design resists tangling, and the inclu...

SKU: AF-4763 | Brand: Adafruit

These little chips are like miniature SSD drives for your electronics. When you don't need something with as much storage as a micro SD card, but an EEPROM is too small, SPI (or QSPI) Flash chips give you on-the-order...

SKU: LB-LS2193 | Brand: Little Bird

A clip-on LED desk light with adjustable brightness and colour temperature, ideal for illuminating soldering work, electronics projects, or general desk tasks. The centre hole lets you look through the light ring whil...

SKU: SF-BOB-16842 | Brand: SparkFun

Buttons are an easy and tactile way to interface with your project, but why would you want to deal with debouncing, polling, and wiring up pull-up resistors? The Qwiic Button with built-in green LED simplifies all of ...

SKU: EF-EF04079 | Brand: ElecFreaks

Octopus TMP36 Temperature Sensor Brick is a temperature sensor with low voltage and accurate celsius read. It can provide voltage output,which forms a linear relationship with celsius temperature. TMP36 do not need an...

SKU: EC-MCS01108S | Brand: Elecrow

The ELE Bluetooth Shield V1.2 adds wireless serial communication to your Arduino or Crowduino via Bluetooth V2.0+EDR. Simply stack it onto your board, select two digital pins (D0–D7) for software serial, and start sen...

SKU: EC-CDE20032P | Brand: Elecrow

An Arduino Uno shield that makes it easy to drive a 16×32 RGB LED matrix panel with a HUB75 connector. Instead of wiring up 12 individual jumper wires, this shield provides a matching 2×8 IDC connector for a clean, re...

SKU: AF-4541 | Brand: Adafruit

A strain gauge is a type of electronic sensor used to measure force or strain (big surprise there). They are made of an insulating flexible backing with a metallic foil pattern. The resistance of a strain gauge change...

SKU: SF-PRT-16581 | Brand: SparkFun

A 2×18 pin female header with standard 0.1" (2.54 mm) pitch spacing. Mates perfectly with the Alchitry Br Prototype Element Board and other 0.1"-spaced dual-row male headers. Specifications Configuration – 2×18 (36...

SKU: EC-RA000022RK | Brand: Elecrow

The GPIO extension kit used for extending the GPIO interface on Raspberry Pi B+, it helps you break out all those tasty power, GPIO, I2C and SPI pins from the 40 pin header of Raspberry Pi B+ onto a breadboard.There i...

SKU: EF-EF03091 | Brand: ElecFreaks

The Wireless Charging Module can be applied in electronic equipments in common use for close wireless charging or power supply. Consisted of a transmitter and insolation coil, it could serve as a replacement for th...

SKU: EF-EF03085 | Brand: ElecFreaks

The HC-SR04 is a widely used ultrasonic distance sensor that provides non-contact measurement from 2 cm to 450 cm with up to 3 mm resolution. It uses a 40 kHz ultrasonic transducer pair — one transmitter and one recei...

SKU: SF-COM-16305 | Brand: SparkFun

Amphenol FCI FFC/FPC Flexible Circuit Connectors are a broad range of innovative connector solutions to terminate FFC/FPC. This 24-Pin FPC connector has a 0.5mm pitch and comes with a bottom contact in a right angle o...

SKU: SF-DEV-15837 | Brand: SparkFun

The SparkFun weather:bit is a fully loaded "carrier" board for the micro:bit that, when combined with the micro:bit, provides you with a fully functional weather station. With the weather:bit you will have acces...

SKU: AF-4482 | Brand: Adafruit

These premium male-male jumper wires are handy for making wire harnesses or jumpering between headers on PCBs. They're 200mm (~7.8") long and come loose as a pack of 40 (10 pieces of red, blue, yellow, and Adafruit bl...

SKU: DF-DFR0646-R | Brand: DFRobot

An 8-digit red LED segment display module with Gravity I2C interface. This module can display numbers, basic characters, and supports 16 levels of brightness adjustment — ideal for clocks, counters, dashboards, and da...

SKU: AF-4444 | Brand: Adafruit

The Adafruit PyPortal Titano is the large-screen version of the popular PyPortal, upgraded to a 3.5" display with twice the pixels (320×480 vs 320×240). Build IoT dashboards, touch screen interfaces, and connected dis...

SKU: MD-SCRU-XL-075 | Brand: Makedo

The Makedo SCRU XL 075 is a 75-piece expansion pack of extra-long reusable connectors for the Makedo cardboard construction system. SCRU XL connectors are designed to join up to six layers of corrugated cardboard, mak...

SKU: EF-EF09087 | Brand: ElecFreaks

The Geekservo Motor is a compact DC motor designed to be fully compatible with LEGO building systems. Its LEGO-compatible mounting points let you integrate motorised movement directly into brick-based builds, making i...