All Products

SKU: PR-PIM183

Ideal for a mini CCTV system, this set of horizontal and vertical motion servos will give you Pi camera movement with a minimum of fuss. Pan-Tilt HAT lets you mount and control one of our pan-tilt modules right on top of your Raspberry Pi. The HAT and its on-board microcontroller let you in...

SKU: SF-ROB-13064

This is a 6 wire slip ring, a remarkably simple electromechanical assembly that allows electronic signals to be passed through its rotating innards. Commonly, you’d find slip rings in wind turbines, radar antennae, or anything else that requires continuous 360° rotation while maintaining an elect...

SKU: AF-5515

Stretch out your servo connections with this flexible servo to premium male header jumper cable. It has a 3-pin shrouded "male" connector to plug the servo into and then, 17cm later, three separated jumper wire ends that plug into a breadboard or some header.It's excellent for when you want ...

SKU: DF-DFR0221

Featured in Make: The Maker's Guide to Boards, DFRobot Leonardo with Xbee Socket is an Arduino Leonardo variant processor.The Arduino Leonardo is based on the ATmega32u4 chip. It is the latest addition to the Arduino family. Compared with the earlier Arduino controllors, by using the ATmega32...

SKU: DF-DFR1108 · MPN: DFR1108

##Introduction Harness the power of the natural environment with the DFM8001 Ambient Energy Harvesting Module. This module is a micro-energy harvesting module that can be used indoors. It efficiently collects and stores energy from abundant sources such as mechanical, thermal, solar, and radio fr...

SKU: DF-DFR0265

The DFRobot Gravity IO Expansion Shield V7.1 simplifies Arduino prototyping by breaking out all digital and analogue pins into colour-coded 3-pin (Signal, Voltage, Ground) Gravity connectors. Plug in sensors, actuators, and modules directly — no soldering or breadboard wiring required. Version 7...

SKU: DF-MBT0044-1 · MPN: MBT0044-1

This bundle adds motor, servo and sensor expansion to the UNIHIKER M10 single-board computer, using the included Type-C to HY2.0-4P communication cable to bridge the M10 to the expansion board.The board includes an integrated 18650 battery holder so your controller, motors and sensors can run fro...

SKU: SF-CAB-19244

The MyoWare 2.0 Reference Cable extends the reference pin on the MyoWare 2.0 Muscle Sensor, allowing you to place the reference electrode on a separate part of the body. This is useful when the sensor's built-in reference pin cannot reach a suitable location, such as a bony portion of the elbow o...

SKU: DF-DFR0843

After purchasing an open-source product that is not electrical level compatible, you may find that your sensor cannot work normally or even is easy to be damaged because the level of the sensor and your controller are not compatible. Apart from the poor experience you encountered, this also cause...

SKU: SF-WRL-24806 · MPN: WRL-24806

The ESP32-C6-WROOM-1 is Espressif's first Wi-Fi 6 module, integrating 2.4 GHz Wi-Fi 6 (802.11ax), Bluetooth 5.3 (LE), and IEEE 802.15.4 (Thread/Zigbee) on a single chip. Built around a high-performance 32-bit RISC-V core clocked up to 160 MHz plus a low-power RISC-V core at 20 MHz, it offers stro...