All Products

SKU: EC-DPO28090B

The NodeMCU V2 is a Wi-Fi development board based on the ESP8266 (ESP-12E module) with an on-board PCB antenna and USB programming interface. It supports 802.11 b/g/n wireless networking and can operate in STA, AP, or STA+AP modes with a built-in TCP/IP stack supporting up to 5 simultaneous TCP c...

SKU: DF-FIT0584 · MPN: FIT0584

This flexible silicone-insulated wire pair is made for high-current power wiring in demanding electronics, robotics and motion-control projects. It uses fine tin-plated copper strands for good conductivity and oxidation resistance, with a twisted multi-strand structure that helps reduce signal in...

SKU: SF-PRT-14765

The SparkFun Single Supply Logic Level Converter is logic level and power supply translator in one small package. This little board breaks out the Texas Instruments TXB0104 4-bit bi-directional voltage-level translator with automatic direction sensing. With this logic level converter you wil...

SKU: SF-WRL-21604 · MPN: WRL-21604

The BMD-34 series is a compact, surface-mount multiprotocol RF module for low-power embedded designs needing Bluetooth 5, Thread or Zigbee connectivity at 2.4 GHz. It is based on the Nordic nRF52840 and combines an Arm Cortex-M4 with FPU, integrated radio and hardware cryptographic engine in a re...

SKU: SS-110990161

A handy assortment of six power connector adaptors and converters for prototyping, electronics projects, and bench setups. This pack covers the most common power connector types — barrel jack, BNC, JST, and screw terminal — so you can quickly adapt between different power sources and devices. Pa...

SKU: PR-PIM082

Explorer HAT Pro adds a lot of useful tools to your Raspberry Pi.It has digital inputs and outputs, capacitive touch pads, croc. clip compatible pads, coloured LEDs, analog inputs, motor drivers, and a mini breadboard for prototyping your projectsGreat for little robots, games, science ...

SKU: DF-DFR0146

The ETH008 is an 8-channel relay module controlled over Ethernet using TCP/IP commands or a built-in HTTP web interface. Each relay is rated up to 16A and features SPCO (Single Pole Change Over) contacts with normally open, normally closed, and common pins available on screw terminals. Individual...

SKU: SF-BOB-15439

The SparkFun PCA9306 Level Translator Breakout provides dual bidirectional voltage-level translation for I2C and SMBus lines. It lets you safely connect devices operating at different logic levels — for example, a 3.3V sensor to a 5V microcontroller — without a direction pin. Simply apply your re...

SKU: LB-LR0046

The 5V 1-Channel Optocoupler Relay Module provides safe, isolated switching of high-voltage loads from a microcontroller. An onboard SMD optocoupler isolates the control circuit from the relay, protecting your Arduino, Raspberry Pi, or other development board from voltage spikes. A jumper settin...

SKU: AF-4613

This ultra-flexible warm white LED strip uses chip-on-board (COB) technology with 320 SMT LEDs per metre, producing a continuous, even glow without visible LED dots. Covered in a translucent silicone diffuser and sealed in a durable silicone tube, the light output resembles neon or incandescent t...

SKU: DF-SEN0282

The MB7076 XL-MaxSonar-WRLA1 is a weather-resistant ultrasonic ranging sensor with centimetre resolution and a 10 Hz read rate. It detects the nearest target from 20 cm to 1068 cm (over 10 metres) and provides three output options: analog voltage, analog envelope, and RS232 serial. Housed in a r...