All Products
Showing 41-46 of 46 products · 14 unavailable products hidden
Metal Cooling Case for LattePanda 3 Delta Single Board Computer
·
##Introduction This meticulously crafted metal enclosure is specifically designed for the LattePanda 3 Delta Single Board Computer. The enclosure fully wraps around the entire LattePanda 3 Delta, including the mainboard fan, while maintaining access to all peripheral interfaces, allowing you to f...
TS01 Non-contact IR Temperature Sensor 0-3V
The DFRobot TS01 is a non-contact infrared temperature sensor that measures surface temperature via infrared radiation. The all-metal IP65 housing provides protection against impact, water, and dust, making it suitable for industrial environments. An integrated optical filter blocks visible and ...
LPB40B IP65 DToF Single-Point Ranging LiDAR Sensor (0.05-40m, UART)
·
The LPB40B is a single-point ranging LiDAR sensor based on Direct Time-of-Flight (DToF) technology. It measures distances from 0.05 to 40 m on high-reflectivity targets, with ±5 cm accuracy across the full range. The DToF principle allows stable operation under strong outdoor lighting up to 100 k...
SparkFun GPS-RTK Dead Reckoning Breakout - ZED-F9R, SMA (Qwiic)
The SparkFun Dead Reckoning Breakout SMA - ZED-F9R is a high precision, sensor fusion GPS board with equally impressive configuration options and takes advantage of u-blox's Automotive Dead Reckoning (ADR) technology. The ZED-F9R module provides a highly accurate and continuous position by fusing...
AM2301B - Wired Enclosed AHT20 - Temperature and Humidity Sensor
·
The AM2301B is an affordable enclosed temperature and humidity sensor featuring an I2C interface — a modern upgrade over the classic DHT22/AM2302 sensors that required bit-bang timing protocols. Inside is the proven AHT20 sensor, delivering reliable readings over standard I2C with support for 2.5...
JST SH Jumper 4 Wire Assembly - 8
This is a simple four wire cable. Great for jumping from board to board or just about anything else. These cables mate with the connectors listed below. They have bare wires on one end and a 4-pin JST SH connector on the other end with a mating socket.
