All Products
Showing 21-27 of 27 products · 33 unavailable products hidden
RTK Torch GNSS Base/Rover Surveying Device
MPN: GPS-25662
Gravity BMP585 Barometric Pressure & Temperature Sensor (I2C/UART)
MPN: SEN0664
6 x AA battery holder with 5.5mm/2.1mm plug
Alkaline AA batteries (LR6) - 4 pack
Adafruit HUZZAH32 – ESP32 Feather Board
16x32 RGB LED Panel Driver Shield
6xAA Battery Holder with DC2.1 Power Jack
RTK Torch GNSS Base/Rover Surveying Device
·
Built for field surveying, this heavy-duty RTK unit combines a multi-band GNSS receiver, internal antenna, battery, Bluetooth, WiFi and a 915MHz LoRa radio in a rugged enclosed design. It is intended to make Base/Rover setup straightforward while handling rough use across varied environments.Gali...
Gravity BMP585 Barometric Pressure & Temperature Sensor (I2C/UART)
·
Built around the Bosch BMP585 chip, this Gravity module measures barometric pressure and temperature for altitude, weather and environmental sensing projects. Its gel-filled cavity and industrial protective cover help it resist water, moisture and chemical exposure, making it better suited to dem...
6 x AA battery holder with 5.5mm/2.1mm plug
A 6×AA battery holder with a 5.5mm/2.1mm DC barrel plug, ready to power Arduino boards and other electronics with a standard DC jack. Use alkaline AAs for approximately 9V at 3000–4000mAh, or rechargeable NiMH cells for 7.2V at ~2000mAh. The 9V alkaline output is ideal for boards with a 5V volta...
Alkaline AA batteries (LR6) - 4 pack
A 4-pack of standard alkaline AA batteries for powering portable electronics, kits, and projects. These use alkaline (MnO2) chemistry with a voltage range of 1.6V (fresh) to 0.8V (depleted) and a typical capacity of approximately 3000mAh. Specifications Type – AA (LR6) Chemistry – Alkaline (M...
Adafruit HUZZAH32 – ESP32 Feather Board
The Adafruit HUZZAH32 ESP32 Feather Board brings the powerful Espressif ESP32 dual-core processor into the Adafruit Feather form factor. With WiFi, Bluetooth Classic, and BLE support, a built-in USB-to-serial converter, automatic bootloader reset, and LiPo battery charging, it's a fully featured ...
16x32 RGB LED Panel Driver Shield
An Arduino Uno shield that makes it easy to drive a 16×32 RGB LED matrix panel with a HUB75 connector. Instead of wiring up 12 individual jumper wires, this shield provides a matching 2×8 IDC connector for a clean, reliable connection between your Arduino and the panel. The shield also includes ...
6xAA Battery Holder with DC2.1 Power Jack
A 6×AA battery holder with a DC 2.1mm power jack that plugs directly into an Arduino's barrel jack input. Creates a 7.2V rechargeable battery pack from NiMH/NiCd cells or a 9V pack from alkaline cells. Features mounting holes for secure installation. Specifications Cell Quantity: 6× AA Output...
