SparkFun

SKU: SF-PRT-13157 | Brand: SparkFun

The SparkFun Breadboard Power Supply Stick provides clean, regulated 3.3 V or 1.8 V power directly to your breadboard. It accepts 4–9 V input via a DC barrel jack or 2-pin header, and outputs regulated voltage through...

SKU: SF-DEV-11013 | Brand: SparkFun

The LilyPad MP3 Player is an all-in-one audio board combining an Arduino-compatible microcontroller, MP3 decoder, microSD card socket, and stereo amplifier. Part of the LilyPad e-textiles line, it's designed to add mu...

SKU: SF-COM-10953 | Brand: SparkFun

The MMA8452Q is a low-power, 3-axis capacitive MEMS accelerometer with 12-bit resolution. Packed with embedded motion-detection functions and configurable interrupt outputs, it can monitor events autonomously while st...

SKU: SF-COM-10931 | Brand: SparkFun

A basic 4-digit 7-segment display in white. This common anode display features one decimal point per digit, plus individually controllable apostrophe and colon points — perfect for clocks, counters, and numeric readou...

SKU: SF-COM-13105 | Brand: SparkFun

So much power and light from such a small package. This 5 pack of “Cool” white 3 Watt aluminum backed PCBs is sure to shed a lot of light on any project you add it to. These LEDs act as any other LED except these l...

SKU: SF-COM-13104 | Brand: SparkFun

So much power and light from such a small package. This 5 pack of “Warm” white 3 Watt aluminum backed PCBs is sure to shed a lot of light on any project you add it to. These LEDs act as any other LED except these litt...

SKU: SF-COM-10924 | Brand: SparkFun

These are massive single pole - double throw (SPDT) sealed relays. This means that when current is applied to the coil it throws a simple changeover switch, terminating the connection from the NC contact to ground and...

SKU: SF-PRT-13102 | Brand: SparkFun

The Raspberry Pi is everybody’s favorite little computer, the last thing that you’d want is for something bad to happen to it. Why not protect it with one of these snazzy plastic enclosures? These cases protect the Ra...

SKU: SF-BOB-13099 | Brand: SparkFun

The SparkFun Rotary Switch Potentiometer Breakout is a small board the allows you to add resistors to a 10-position rotary switch, turning it into a potentiometer with 10 discrete steps. Multiple applications requi...

SKU: SF-DEV-10914 | Brand: SparkFun

It’s blue! It’s skinny! It’s the Arduino Pro! SparkFun’s minimal design approach to Arduino. This is a 3.3V Arduino running the 8MHz bootloader. Because the system voltage for this board is lower than other Arduino...

SKU: SF-PRT-13061 | Brand: SparkFun

This 6 position screw terminal block provides a simple way to connect wires to a single connection point. These blocks allow wires to be screwed together and self-isolated without needing to twist, solder or any other...

SKU: SF-ROB-10848 | Brand: SparkFun

These steppers have a threaded shaft, which allows them to be used as a linear actuator. As the motor runs, it moves along the shaft at a specific rate of 1cm per 5 full rotations. These are a good choice for linear m...

SKU: SF-PRT-10853 | Brand: SparkFun

This is a wire assembly terminated with the same 8-pin JST-SH connector which is on the Mega Pro Mini. Pick up a few of these to break out all of those pesky pins. Integrating these connectors into your projects ma...

SKU: SF-TOL-10829 | Brand: SparkFun

This smart SMD tester is essentially a pair of multimeter tweezers. This allows you to troubleshoot circuits with small SMD parts without having to fumble with large probes or long wires. Test resistors, capacitors an...

SKU: SF-WRL-13002 | Brand: SparkFun

This ANT500 is a telescopic antenna designed for operation from 75 MHz to 1 GHz with a total length that is configurable from 20 cm to 88 cm long. Each ANT500 is constructed of stainless steel and features an SMA male...

SKU: SF-CAB-10759 | Brand: SparkFun

Integrating Ethernet support into your project is a great way to relay data through a local area network and even bounce information out to the internet. Sometimes it’s hard to get power to your Ethernet devices. Woul...

SKU: SF-PRT-10739 | Brand: SparkFun

Metal short standoffs: 3/8" long x ¼"OD. Used to get your proto board up off the table. #4-40 thread. Fits all development boards with available holes. Don’t forget the screws! Related below. Note: These are sold as a...

SKU: SF-PRT-10687 | Brand: SparkFun

A 33-metre roll of polyimide (Kapton-style) tape that withstands temperatures up to 258°C (496°F). This high-temperature adhesive tape is an excellent electrical insulator with good corrosion resistance, and its silic...

SKU: SF-TOL-10721 | Brand: SparkFun

This is a replacement soldering tip for our Hakko FX-888 soldering iron. This is a conical type of soldering tip. Replacing the tip is very easy - simply unscrew the shield, slip the replacement tip in, and screw t...

SKU: SF-WRL-12938 | Brand: SparkFun

The SparkFun FM Tuner Evaluation Board features the Silicon Laboratories Si4703 FM tuner chip, capable of receiving FM radio stations as well as detecting and processing Radio Data Service (RDS) and Radio Broadcast Da...