Sound & Audio

SKU: DF-DFR0119 | Brand: DFRobot

This compact stereo amplifier module from DFRobot is based on the PAM8403 chip, delivering 3W per channel into 4Ω speakers with over 90% efficiency. It's a fully functional two-channel audio amplifier with an integrat...

SKU: DF-DFR0308 | Brand: DFRobot

The Arduino DTMF Shield is a dual-tone multi-frequency decoder module that lets your Arduino interpret touch-tone signals from phones. Connect it to a GSM/GPRS shield and you can send commands to your Arduino via phon...

SKU: SF-DEV-10587 | Brand: SparkFun

Do you ever wish your Arduino was more musically talented? Or maybe your project could use some cool sound effects. The SparkFun Musical Instrument Shield is an easy way to add great sounding MIDI sound to your next A...

SKU: DF-TEL0108 | Brand: DFRobot

This Bluetooth audio receiver module supports wireless streaming, USB flash drive, and TF (microSD) card playback. It decodes MP3, WMA, WAV, and lossless FLAC audio formats, with a built-in pre-amp output capable of d...

SKU: AF-1381 | Brand: Adafruit

This breakout board is the ultimate companion for the VLSI VS1053B DSP codec chip. The VS1053 can decode a wide variety of audio formats such as MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM). It can al...

SKU: DF-SEN0232 | Brand: DFRobot

The Gravity Analog Sound Level Meter is an Arduino-compatible decibel meter that accurately measures environmental noise levels. It uses an instrumentation-grade circuit with a low-noise microphone for high-precision ...

SKU: DF-DFR0126 | Brand: DFRobot

This Audio Analyzer module features the MSGEQ7 graphic equalizer display filter.It will give your arduino ears. Sound is broken down into seven frequency bands and the peak level for each band can be read. The seven ...

SKU: SF-COM-10468 | Brand: SparkFun

The MSGEQ7 is a CMOS graphic equaliser IC that divides the audio spectrum into seven frequency bands: 63 Hz, 160 Hz, 400 Hz, 1 kHz, 2.5 kHz, 6.25 kHz, and 16 kHz. Each band is peak-detected and multiplexed to provide ...

SKU: SF-SEN-12642 | Brand: SparkFun

The SparkFun Sound Detector is a small and very easy to use audio sensing board with three different outputs. The Sound Detector not only provides an audio output, but also a binary indication of the presence of so...

SKU: AF-3482 | Brand: Adafruit

This Panel Mount 10K Dual Logarithmic Potentiometer w/ On-Off Switch is a two-in-one; you get a dual-ganged potentiometer and an on-off switch. For the potentiometer-half, you've got a dual standard log-t...

SKU: AF-5954 | Brand: Adafruit

The Adafruit TRRS Trinkey is a USB-A plug-in microcontroller designed specifically for assistive technology. It combines an ATSAMD21 processor with a switched TRRS 3.5mm audio jack, connecting all 6 jack pins (tip, ri...

SKU: DF-DFR0805 | Brand: DFRobot

Make a subwoofer speaker with this bass & treble control Bluetooth Amplifier to enjoy the cinema-style acoustics in the home! Integrated with 3 output channels, this powerful Bluetooth Amplifier has AM interference an...

SKU: DF-DFR0782 | Brand: DFRobot

An evaluation board for a dual-mode Bluetooth 5.0 module that handles both wireless audio and serial data pass-through simultaneously. It can play audio from U-disk or TF card, stream audio over Bluetooth, handle Blue...

SKU: AF-4361 | Brand: Adafruit

Pipe audio in or out of your project with this very handy panel mount audio jack. It's a mono jack with a disconnect pin so you'll get a ground sleeve pin, a left tip pin and a pin that will be disconnected when a jac...

SKU: DF-DFR0498 | Brand: DFRobot

DFRobot FireBeetle series are low power consumption development modules designed for Internet of Things (IoT). The FireBeetle Covers-Camera & Audio Media Board is a multimedia device for IoT that provides interfac...

SKU: KI-46124 | Brand: Kitronik

The MonkMakes Speaker Board is a compact, amplified speaker designed for the BBC micro:bit. Simply connect it with crocodile clips and start adding sound to your micro:bit projects — despite its small size, the speake...

SKU: AF-1552 | Brand: Adafruit

This incredibly small stereo amplifier is surprisingly powerful - able to deliver 2 x 2.1W channels into 4 ohm impedance speakers (@ 10% THD). Inside the miniature chip is a class D controller, able to run from 2.7V-5...

SKU: AF-2793 | Brand: Adafruit

One truth about working with A/V is you always need the cable or adapter you don't have in your toolbox. That's why we love these terminal-block RCA connectors so much. No soldering required! Use stranded or solid ...

SKU: AF-2792 | Brand: Adafruit

One truth about working with A/V is you always need the cable or adapter you don't have in your toolbox. That's why we love these terminal-block RCA connectors so much. No soldering required! Use stranded or solid ...

SKU: AF-2911 | Brand: Adafruit

A 1/4" (6.35 mm) stereo plug with screw terminal connections — no soldering required. Simply insert stranded or solid-core wire into the terminal block and tighten with a small screwdriver to create custom audio wirin...