Sound & Audio

SKU: AF-1890 | Brand: Adafruit

Listen up! This tiny 1" diameter speaker cone is the perfect addition to any small audio project where you need an 8 Ω impedance and will be using 0.5W or less of power. We particularly like this cone as it's very ...

SKU: AF-5791 | Brand: Adafruit

The Adafruit STEMMA Piezo Driver Amp uses the PAM8904 switched-capacitor driver to amplify signals for piezo elements at up to 300 kHz. With bridge-tied load (BTL) output and up to 3× voltage multiplication, it can de...

SKU: AF-1699 | Brand: Adafruit

Pipe audio in or out of your project with this very handy breadboard-friendly audio jack. It's a stereo jack with disconnect-switches on Left and Right channels as well as a center ground pin. You can use any 3.5mm...

SKU: AF-1740 | Brand: Adafruit

This small (14mm diameter) piezo element is nicely enclosed so you can attach easily. Piezo elements convert vibration to voltage or voltage to vibration. That means you can use this as a buzzer for making beeps, tone...

SKU: LB-LS1891 | Brand: Little Bird

HS1891 DAC Module CJMCU-1334 UDA1334A I2S DAC Audio Stereo Decoder Module Board 3.3V - 5V Feature: This fully-featured UDA1334A I2S Stereo DAC breakout is a perfect match for any I2S-output audio interface.&nbsp...

SKU: AF-2914 | Brand: Adafruit

A 3.5 mm (1/8") 4-pole TRRS audio plug with screw terminal connections — no soldering required. Use stranded or solid-core wire and a small screwdriver to create custom audio cables, breakouts, and test leads. TRRS s...

SKU: DF-FIT0449 | Brand: DFRobot

INTRODUCTION This speaker module is based on the 8002 speaker amplifier IC. It can be used as a buzzer and also play high quality audio. Volume output is controlled via the potentiomet...

SKU: AF-987 | Brand: Adafruit

This incredibly small stereo amplifier is surprisingly powerful - able to deliver 2 x 3.7W channels into 3 ohm impedance speakers. Inside the miniature chip is a class D controller, able to run from 2.7V-5.5VDC. Since...

SKU: EC-ASVS1053MP | Brand: Elecrow

An Arduino-compatible MP3 shield based on the VS1053B audio codec from VLSI. It decodes all major audio formats — including MP3, OGG Vorbis, AAC, WMA, FLAC, WAV, and MIDI — and can record in Ogg Vorbis, IMA ADPCM, and...

SKU: SF-SEN-14262 | Brand: SparkFun

The SparkFun Sound Detector is a small and very easy-to-use audio sensing board with three different outputs. The Sound Detector not only provides an audio output, but also a binary indication of the presence of sound...

SKU: SF-WIG-13660 | Brand: SparkFun

The WAV Trigger is a unique high-fidelity polyphonic audio player with surprising capabilities. Supporting up to 2048 uncompressed 16-bit, 44.1kHz wav files – the same quality as an audio CD – the WAV Trigger can p...

SKU: SF-DEV-13116 | Brand: SparkFun

The SparkFun Spectrum Shield splits a stereo audio input into 7 frequency bands per channel using two MSGEQ7 graphic equaliser ICs. Read the amplitude of each band via your Arduino's ADC to create sound-reactive proje...

SKU: SF-BOB-12758 | Brand: SparkFun

The SparkFun Electret Microphone Breakout pairs a small electret microphone capsule with a 60× OPA344 op-amp preamplifier, making it easy to detect sound with a microcontroller's analogue-to-digital converter. Pick up...

SKU: DF-DFR0034 | Brand: DFRobot

This is a new Arduino compatible Analog Sound Sensor. Sound Sensor is typically used in detecting the loudness in ambient, the Arduino can collect its output signal and actuate accordingly. You may use it to make some...

SKU: LB-LS6972x2 | Brand: Little Bird

A compact stereo speaker pair for small audio projects, handheld devices, and embedded builds. Each 45mm driver is rated at 4Ω and 3W, delivering clear, balanced sound in a slim form factor. Pre-wired with a PH2.0 plu...

SKU: AF-6251 | Brand: Adafruit

The Adafruit PCM5100 I2S DAC converts digital I2S audio into clean, high-quality stereo line-level output through a 3.5mm jack. With 100dB signal-to-noise ratio and no MCLK or I2C configuration required, simply pipe I...

SKU: AF-5647 | Brand: Adafruit

The Adafruit STEMMA Audio Amp is a compact mono Class D amplifier based on the PAM8302 chip, delivering up to 2.5W into 4 Ω speakers from a 2.0–5.5V DC supply. With over 90% efficiency at half a watt into 8 Ω, it's id...

SKU: SF-BOB-19389 | Brand: SparkFun

The SparkFun Analog MEMS Microphone Breakout makes it easy to work with the SPH8878LR5H-1 analog microphone from Knowles. This board features an OpAmp to bring the output of the microphone to a usable level, allowing ...

SKU: PR-PIM356 | Brand: Little Bird

Make your micro:bit sing with noise:bit! It's a tiny speaker that packs a fair bit of punch, and it's perfect for BLEEPS and BLOOPS! Just slot in your micro:bit, and use the sound generation blo...

SKU: AF-2790 | Brand: Adafruit

A 3.5 mm (1/8") stereo (TRS) audio plug with screw terminal connections — no soldering required. Use stranded or solid-core wire and a small screwdriver to create custom audio cables, breakouts, and test leads. This ...