Power & Batteries

SKU: AF-3898 | Brand: Adafruit

Lithium ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light and powerful. The output ranges from 4.2V when completely charged to 3.7V. This battery has a capacity of 400mAh for a total of about...

SKU: DF-FIT0265 | Brand: DFRobot

Micro USB 2.0 to USB type A cable, a standard USB connector for cellphones, Arduino Leonardo or other embeded boards to common computer connector. This is a consumer standard, smaller connector for USB devices. Mic...

SKU: AF-261 | Brand: Adafruit

Red and black tinned wires with a 2-pin JST PH connector on the end. 4" / 100mm long. Matches up nicely with our Lipoly chargers! We have the socket 'mating' version of this cable over here, as well as an 'ex...

SKU: AF-353 | Brand: Adafruit

A high-capacity 3.7 V lithium-ion battery pack built from three 2200 mAh 18650 cells connected in parallel, providing 6600 mAh of total capacity. The cells are spot-welded to a built-in protection circuit that guards ...

SKU: LB-LS1558 | Brand: Little Bird

A standard 18650 lithium-ion rechargeable battery with a built-in protection circuit for safe operation. The integrated PCB provides overcharge, over-discharge, and short-circuit protection, making it a reliable power...

SKU: DF-DFR0264 | Brand: DFRobot

This Solar lipo charger is designed for single Lithium battery (3.7V) for intelligent charging, with input reverse polarity protection. The maximum charging current is 500 milliamperes and the connection is si...

SKU: DF-FIT0111 | Brand: DFRobot

A classic 9V battery snap connector with bare wire leads, 15 cm in length. Pair it with a DC Barrel Jack Adapter – Male to power an Arduino directly from a 9V battery. Key Features Bare Wire Leads – Solder or conne...

SKU: AF-1566 | Brand: Adafruit

A large-sized rechargeable battery pack for your Raspberry Pi (or Arduino, or Propeller, or anything else that uses 5V!). This pack is intended for providing a lot of power to an GPS, cell phone, tablet, etc but...

SKU: DF-DFR1015 | Brand: DFRobot

Multiple-output DC–DC converters are essential in a multitude of applications where different DC output voltages are required.This DC-DC step-down voltage power module converts 7.5V~30V input to an output of 3.3V/5V/9...

SKU: LB-LS0221 | Brand: Little Bird

The CJMCU-226 INA226 is a powerful voltage, current, and power monitoring module designed for high precision in both high-side and low-side sensing applications. With its bi-directional current sensing capability and ...

SKU: AF-5450 | Brand: Adafruit

This cable will let you get rid of all those wall adapters you have stashed in the plastic bin in the basement. Instead of multiple wall warts with different power and current capabilities, this cable will convert any...

SKU: AF-4090 | Brand: Adafruit

The Adafruit USB C Breakout Board (Downstream Connection) gives you easy access to all the pins on a USB Type-C connector, configured for downstream device use. Two 5.1K resistors on the CC1 pins signal the upstream h...

SKU: DF-DFR0123 | Brand: DFRobot

This 20W adjustable DC-DC boost converter with a digital display is based on the professional boost chip and supports 3~32V power input, 5~35V output, and an accuracy of ±0.05V. The switching frequency is 400KHz, th...

SKU: AF-4236 | Brand: Adafruit

A 3.7 V lithium-ion polymer (LiPo) battery with 420 mAh capacity (approximately 1.55 Wh). It features a short cable with a genuine 2-pin JST-PH connector that clicks smoothly into matching JST jacks without snagging. ...

SKU: DF-DFR0559 | Brand: DFRobot

The Sunflower Solar Power Manager 5V is a high-efficiency solar power management module designed for 5 V solar panels. It features MPPT (Maximum Power Point Tracking) to maximise solar panel efficiency, and supports d...

SKU: DF-DFR0946 | Brand: DFRobot

This adjustable power module combines boost and buck regulation so it can hold a stable output voltage even when the input is above or below the set output. It is suited to industrial power supplies, DIY smart power s...

SKU: DF-DFR0140 | Brand: DFRobot

This is a very simple board that takes a 6-12V input voltage and outputs a selectable 5V or 3.3V regulated voltage. All headers are 0.1" pitch for simple insertion into a breadboard. It can be either powered from 6-12...

SKU: DF-DFR0559-1 | Brand: DFRobot

Note: Includes Solar Power Manager 5V and Semi Flexible Monocrystalline Solar Panel (5V 1A). The DFRobot Solar Power Manager series are designed for IoT projects and renewable energy projects, providing safe and hi...

SKU: DF-FIT0641 | Brand: DFRobot

This 1-metre USB-A to USB-C cable supports both data transfer and power delivery at up to 5V/3A (15W). It provides a reliable connection for charging and programming USB-C devices including the Raspberry Pi 4B, Jetson...

SKU: DF-DFR0667 | Brand: DFRobot

This Charger - MicroUSB is designed for single-cell 3.7V lithium battery. With its tiny body, you can easily integrate it into your applications. The charger adopts TP4056X lithium battery charging IC, which guarantee...