DFRobot
Shop DFRobot products at Little Bird Electronics, your Australian source for this trusted maker brand. From the Gravity sensor range to FireBeetle IoT boards, DFRobot delivers reliable modules, displays, motors, and converters for every project.
Ideal for STEM education, robotics, Arduino and Raspberry Pi builds, and professional prototyping. Shipped from Australia with local support for hobbyists, educators, and engineers alike.
Micro:bit Driver Expansion Board
SKU: DF-DFR0548 | Brand: DFRobot
Since the advent of micro:bit, its simple and practical way of programming is widely loved by makers, students and teachers. Its sample design, coupled with a wealth of pin resources, give it infinite possibiliti...
Delivered by Fri 19 Jun
Arduino Nano ESP32 with headers
SKU: DF-DFR1096 | Brand: DFRobot
The Arduino Nano ESP32 brings the ESP32-S3 (u-blox NORA-W106 module) into the familiar Nano form factor with a USB-C connector. It supports both Arduino and MicroPython programming, making it an accessible entry point...
Delivered by Fri 19 Jun
USB GPS Receiver (2m Extension Cable)
SKU: DF-TEL0138 | Brand: DFRobot
This is an Ublox chip-based GPS receiver module of low power and high sensitivity that can receive 56 channels satellite signal. Compared with traditional GPS receivers, it brings much more accurate and faster-positio...
Delivered by Fri 19 Jun
Waterproof DS18B20 Sensor Kit
SKU: DF-KIT0021 | Brand: DFRobot
A waterproof DS18B20 digital temperature sensor kit with everything you need to connect to an Arduino. The stainless steel probe measures temperatures from -55°C to +125°C over a 1-Wire interface, requiring just one d...
Delivered by Wed 10 Jun
Gravity: Analog Turbidity Sensor For Arduino
SKU: DF-SEN0189 | Brand: DFRobot
The Gravity Analog Turbidity Sensor measures water clarity by detecting the level of suspended particles. It works by measuring light transmittance and scattering rate, which change with the amount of total suspended ...
Delivered by Fri 19 Jun
Gravity: Tipping Bucket Rainfall Sensor - I2C & UART
SKU: DF-SEN0575 | Brand: DFRobot
This DFRobot rainfall sensor is a reliable and convenient tool for measuring rainfall.Based on the principle of tipping bucket rainfall, the rainfall sensor provides users with rainfall values in millimeters and syste...
Delivered by Fri 19 Jun
IR Break Beam Sensor (50cm)
SKU: DF-SEN0503 | Brand: DFRobot
An infrared break-beam sensor pair for simple, reliable motion detection. The emitter sends a beam of invisible IR light to the receiver — when an object passes between them and breaks the beam, the receiver outputs a...
Delivered by Fri 19 Jun
Gravity: MOSFET Power Controller
SKU: DF-DFR0457 | Brand: DFRobot
In most Arduino projects, relays are the first choice to drive some large current device. It requires a certain amount of current to drive the internal coil to pick-up contact. But for some MCU, like Intel Edison,...
Delivered by Fri 19 Jun
Beetle ESP32 Microcontroller
SKU: DF-DFR0575 | Brand: DFRobot
Is FireBeetle-ESP32 too big for your projects? Why not try our newly launched Beetle-ESP32. This Beetle-ESP32 Microcontroller of 1.38”×1.34”small size is a simplified version of FireBeetle-ESP32 and specially designed...
Delivered by Fri 19 Jun
6 DOF Sensor - MPU6050
SKU: DF-SEN0142 | Brand: DFRobot
A compact breakout board for the MPU-6050, combining a 3-axis gyroscope and 3-axis accelerometer with an onboard Digital Motion Processor (DMP) on a single chip. The integrated DMP handles complex motion fusion algori...
Delivered by Fri 19 Jun
Gravity: Analog TDS Sensor/Meter for Arduino
SKU: DF-SEN0244 | Brand: DFRobot
The Gravity Analog TDS Sensor is an Arduino-compatible kit for measuring Total Dissolved Solids (TDS) in water. TDS indicates how many milligrams of soluble solids are dissolved per litre — the higher the value, the l...
Delivered by Wed 10 Jun
Arduino Uno Rev 3
SKU: DF-DFR0181 | Brand: DFRobot
This is the new Arduino Uno Rev 3. In addition to all the features of the previous board, the arduino Uno Rev 3 now uses an ATmega16U2 instead of the 8U2 found on the Uno (or the FTDI found on previous generations). T...
Delivered by Wed 10 Jun
Beetle ESP32 - C3 (RISC-V Core Development Board)
SKU: DF-DFR0868 | Brand: DFRobot
The Beetle ESP32-C3 is a coin-sized IoT development board based on the ESP32-C3 RISC-V 32-bit single-core processor. Measuring just 25 × 20.5 mm, it breaks out up to 13 GPIO pins and integrates lithium battery chargin...
Delivered by Wed 10 Jun
Gravity: I2C LCD1602 Arduino LCD Display Module (Green)
SKU: DF-DFR0556 | Brand: DFRobot
A 16×2 character LCD display module from DFRobot's Gravity series, connecting to your Arduino or microcontroller via a simple I²C interface — just two data wires instead of the many parallel connections a standard LCD...
Delivered by Wed 10 Jun
Gravity: Analog Water Pressure Sensor
SKU: DF-SEN0257 | Brand: DFRobot
The Gravity Analog Water Pressure Sensor measures water or gas pressure and outputs a linear 0.5–4.5 V analogue signal proportional to the applied pressure (0–1.6 MPa). Using the DFRobot Gravity 3-pin interface, it co...
Delivered by Wed 10 Jun
TCS3200 RGB Color Sensor For Arduino
SKU: DF-SEN0101 | Brand: DFRobot
An RGB colour sensor breakout board based on the TAOS TCS3200 chip, with four built-in white LEDs for illumination. The TCS3200 can detect and measure a wide range of visible colours by converting light intensity to a...
Delivered by Fri 19 Jun
Gravity: Soil Moisture Sensor For Arduino
SKU: DF-SEN0114 | Brand: DFRobot
A resistive soil moisture sensor that reads the water content of surrounding soil by measuring electrical resistance between its two probes. Wetter soil conducts more easily (lower resistance), while dry soil conducts...
Delivered by Fri 19 Jun
Gravity: I2C LCD1602 Arduino LCD Display Module (Gray)
SKU: DF-DFR0557 | Brand: DFRobot
The Gravity I2C LCD1602 is a 16×2 character LCD display module from DFRobot's Gravity series, redesigned with a clean modern look and simplified I2C interface. It eliminates the need for contrast adjustment, retains b...
Delivered by Wed 10 Jun
Gravity: Non-contact Arduino Water / Liquid Level Sensor
SKU: DF-SEN0204 | Brand: DFRobot
A non-contact liquid level sensor that detects the presence of liquid through a container wall — no direct contact with the liquid required. Using advanced signal processing via the XKC-Y25-T12V chip, it works through...
Delivered by Wed 10 Jun
Gravity: Non-contact IR Temeperature Sensor For Arduino
SKU: DF-SEN0206 | Brand: DFRobot
INTRODUCTION We can divide temperature measurement in to two types: contact and non-contact. Contact measurement can only accurately measure temperature when the testing object and the se...
Delivered by Fri 19 Jun
Compare your options
All buying guides
The Teacher's Guide to micro:bit Robots: Kits, Buggies, and Robotics Compared
Compare micro:bit-compatible robot kits, buggies, and robotics platforms by age range, assembly difficulty, sensors, and curriculum fit — for classrooms, clubs, and home learners across Australia.
49 products compared
The Maker's Guide to Servos: Torque, Speed, and Control Compared
Compare hobby and industrial servos by torque, rotation range, and control type (PWM, digital, continuous) to pick the right motor for robotics, animatronics, and RC projects.
16 products compared
Title The Maker's Guide to ADCs: Resolution, Speed, and Interface Compared
Compare analogue-to-digital converters by bit depth, sample rate, and bus (I²C vs SPI) to pick the right chip for your Arduino, Raspberry Pi, or microcontroller project.
16 products compared
