Audio

SKU: AF-3346 | Brand: Adafruit

The Adafruit I2S 3W Stereo Speaker Bonnet adds high-quality digital audio output to any Raspberry Pi with a 2×20 GPIO header. Using the I2S digital sound standard, audio data goes directly to the onboard Class D ampli...

SKU: DF-FIT0449 | Brand: DFRobot

INTRODUCTION This speaker module is based on the 8002 speaker amplifier IC. It can be used as a buzzer and also play high quality audio. Volume output is controlled via the potentiomet...

SKU: AF-987 | Brand: Adafruit

This incredibly small stereo amplifier is surprisingly powerful - able to deliver 2 x 3.7W channels into 3 ohm impedance speakers. Inside the miniature chip is a class D controller, able to run from 2.7V-5.5VDC. Since...

SKU: SF-COM-11143 | Brand: SparkFun

This is a simple 3.5mm TRS stereo audio jack with a screw-on plastic shroud. These are great for projects that plug into headphone jacks. Stereo plugs can also be used for carrying serial comm connections!  Th...

SKU: AF-1891 | Brand: Adafruit

Listen up! This 1.5" diameter speaker cone is the perfect addition to any audio project where you need an 8Ω impedance and are using 0.25W of power. The speakers are rated at 0.25W, with a maximum input of 0.5W (pr...

SKU: SF-PRT-08032 | Brand: SparkFun

Low profile 3.5mm stereo audio jack.Documents:Audio 3.5mm Jack Datasheet

SKU: DF-DFR0719 | Brand: DFRobot

A compact Bluetooth 5.0 audio receiver board that turns any wired speaker into a wireless one. Simply connect power (3.7–24V) and wire up your speaker — pair it with your phone and start streaming music wirelessly. Th...

SKU: DF-DFR0745 | Brand: DFRobot

Wanna buy a simple & practical voice recorder? This one is right for you! The voice recorder module supports 4 controlling modes (Arduino, AT command, on-board buttons, and ADKEY), and multi-segment voice recording. Y...

SKU: AF-3492 | Brand: Adafruit

The Adafruit PDM MEMS Microphone Breakout provides a digital audio input using Pulse Density Modulation (PDM) — a common interface in commercial products that's distinct from both analogue and I2S microphones. It's id...

SKU: SF-SEN-14262 | Brand: SparkFun

The SparkFun Sound Detector is a small and very easy-to-use audio sensing board with three different outputs. The Sound Detector not only provides an audio output, but also a binary indication of the presence of sound...

SKU: SF-COM-09151 | Brand: SparkFun

A compact 0.5W speaker with 8 ohm impedance, small enough to fit inside robot builds, enclosures, and portable electronics projects. Suitable for audio output from amplifier boards, microcontrollers with DAC/PWM audio...

SKU: SF-COM-14023 | Brand: SparkFun

This will be a treat for your ears! The Hamburger Mini Speaker is a 3W economical speaker option for any project needing stand-alone sound. The Hamburger features a built-in lithium polymer battery for portable app...

SKU: SF-WIG-13660 | Brand: SparkFun

The WAV Trigger is a unique high-fidelity polyphonic audio player with surprising capabilities. Supporting up to 2048 uncompressed 16-bit, 44.1kHz wav files – the same quality as an audio CD – the WAV Trigger can p...

SKU: SF-DEV-12898 | Brand: SparkFun

The SparkFun MIDI Shield board gives your Arduino-based device access to the antiquated, but still widely used and well supported MIDI communication protocol, so you can control synthesizers, sequencers, and other ...

SKU: SF-PRT-12639 | Brand: SparkFun

A 3.5mm TRRS (tip, ring, ring, sleeve) audio jack in a surface-mount package. Unlike standard stereo TRS connectors, TRRS provides three conductors plus ground, allowing it to carry stereo audio along with an addition...

SKU: DF-DFR0034 | Brand: DFRobot

This is a new Arduino compatible Analog Sound Sensor. Sound Sensor is typically used in detecting the loudness in ambient, the Arduino can collect its output signal and actuate accordingly. You may use it to make some...

SKU: LB-LS6972x2 | Brand: Little Bird

A compact stereo speaker pair for small audio projects, handheld devices, and embedded builds. Each 45mm driver is rated at 4Ω and 3W, delivering clear, balanced sound in a slim form factor. Pre-wired with a PH2.0 plu...

SKU: AF-6251 | Brand: Adafruit

The Adafruit PCM5100 I2S DAC converts digital I2S audio into clean, high-quality stereo line-level output through a 3.5mm jack. With 100dB signal-to-noise ratio and no MCLK or I2C configuration required, simply pipe I...

SKU: AF-5770 | Brand: Adafruit

The Adafruit I2S Amplifier BFF is a compact add-on that brings high-quality 3W audio to any QT Py or Xiao development board. Featuring a MAX98357 Class D amplifier, it delivers crisp I2S digital audio using just three...

SKU: SF-PRT-20660 | Brand: SparkFun

This is a small 15mm round speaker that operates around the audible 2kHz range. You can use these speakers to create simple music or user interfaces.This through-hole speaker is great for projects where you don't have...