Audio

This A/V RCA Cable for Raspberry Pi is a great way to turn your Pi 3, 2, A+ or B+'s output into a full on composite video and audio device.  Simply...

Listen to this good news - we now have an all in one digital audio amp breakout board that works incredibly well with the Raspberry Pi! If you'r...

Listen up! This 2.8" x 1.2" speaker is a great addition to any audio project where you need 4 ohm impedance and 3W or less of power. We parti...

Add some crisp and compact audio to your project with this Mini External USB 2.0 Speaker. It's USB-only and does not require or use a 3.5mm audi...

INTRODUCTION FIT0502(Stereo Enclosed Speaker) is a new passive speaker with JST PH2.0 interface. It is a perfect option for any DIY audio project w...

This digital I2S MEMS Microphone works well with microcontrollers with I2S audio outputs like ESP32. Compared with traditional analog ones, this mi...

Raspberry Pi can not be used directly with the speaker, so this speaker is a built-in power amplifier dual-channel speaker, driver-free, USB pow...

This is a compact and cost-effective Bluetooth 5.0 audio receiver module that supports automatic reconnect function. It can be powered by a micr...

Add an ear to your project with this well-designed electret microphone amplifier. This fully assembled and tested board comes with a 20-20KHz el...

Pipe audio in or out of your project with this very handy breadboard-friendly audio jack. It's a stereo jack with disconnect-switches on Left an...

Listen up! This set of two 2.8" x 1.2" speakers are the perfect addition to any audio project where you need 4 ohm impedance and 3W or less of p...

Would you like to add audio/sound effects to your next project, without an Arduino+Shield? Or maybe you don't even know how to use microcontrol...

Introducing our cutting-edge USB Type C Headphone Jack Adapter! This innovative audio adapter allows you to easily connect your favorite headphones...

Add some crisp and compact audio to your project with this Mini External USB 2.0 Speaker. It's USB-only and does not require or use a 3.5mm audio j...

This is a small size and cost-effective Bluetooth 4.2 Audio Receiver module with dual 5W power amplifier circuits. It supports auto-reconnect and c...

This cable is easy to understand - you get a 3.5mm mono audio plug on one end, and two alligator clips on the other. It's also really easy to use, ...

Description: This 2M HDMI Cable is perfect to plugging you Raspberry Pi into your HDMI enabled monitor or television. Dimensions:   Connector Type ...

This sound-detection sensor module is highly sensitive. It can detect when sound reaches a set threshold level.  There are two output pins, o...

This 5m length of EL wire (electroluminescent wire) is a flexible wire coated with phosphor which glows blue when applied with the appropriate volt...

The Raspberry Pi has an on-board audio jack, which is super handy for all kinds of sound effects and speech, just plug and go! However, for when yo...

What is this TRS bit? Turtle Rock Studios? Transmission Raman Spectroscopy? Not quite, more like Tip-Ring-Sleeve. This nifty, gold-plated connector...

Would you like to add audio/sound effects to your next project, without an Arduino+Shield? Or maybe you don't even know how to use microcontroller...

This is a small 12mm round speaker that operates around the audible 2kHz range. You can use these speakers to create simple music or user interface...

This small breakout board couples an Electret microphone (100Hz–10kHz) with a 60x mic preamplifier to amplify the sounds of voice, claps, door knoc...