Audio Processing Modules

SKU: AF-3692 | Brand: Adafruit

What is this TRS bit? Turtle Rock Studios? Transmission Raman Spectroscopy? Not quite, more like Tip-Ring-Sleeve. This nifty, gold-plated connector is known by many names, phone plug, phone jack, headphone j...

SKU: AF-2791 | Brand: Adafruit

A 3.5 mm (1/8") stereo (TRS) audio jack with screw terminal connections — no soldering required. Use stranded or solid-core wire and a small screwdriver to create custom audio wiring jigs, breakouts, and test setups. ...

SKU: AF-5791 | Brand: Adafruit

The Adafruit STEMMA Piezo Driver Amp uses the PAM8904 switched-capacitor driver to amplify signals for piezo elements at up to 300 kHz. With bridge-tied load (BTL) output and up to 3× voltage multiplication, it can de...

SKU: DF-DFR0799 | Brand: DFRobot

This mini Bluetooth Amplifier can be connected to your mobile phone, Raspberry Pi, and other main-boards with Bluetooth to DIY your unique speaker! With standard audio quality, the cost-effective amplifier offers 50W ...

SKU: AF-2341 | Brand: Adafruit

The Adafruit Audio FX Mini Sound Board is a standalone audio trigger that plays WAV and OGG Vorbis files — no Arduino or programming required. Simply drag and drop sound files over USB, wire up buttons to the trigger ...

SKU: DF-DFR0803 | Brand: DFRobot

A HiFi digital power amplifier board with Bluetooth 5.0 and AUX input, delivering 50W per channel in a dual-channel configuration. With AM interference suppression and filtering, the board achieves THD as low as 0.1% ...

SKU: AF-2914 | Brand: Adafruit

A 3.5 mm (1/8") 4-pole TRRS audio plug with screw terminal connections — no soldering required. Use stranded or solid-core wire and a small screwdriver to create custom audio cables, breakouts, and test leads. TRRS s...

SKU: AF-2881 | Brand: Adafruit

An A/V RCA cable designed for the Raspberry Pi 3, 2, A+ and B+. Connect the 3.5 mm TRRS jack to your Pi and the RCA plugs to any composite video and stereo audio display or TV. Key Features Correct TRRS Wiring – Pi...

SKU: AF-3346 | Brand: Adafruit

The Adafruit I2S 3W Stereo Speaker Bonnet adds high-quality digital audio output to any Raspberry Pi with a 2×20 GPIO header. Using the I2S digital sound standard, audio data goes directly to the onboard Class D ampli...

SKU: DF-FIT0449 | Brand: DFRobot

INTRODUCTION This speaker module is based on the 8002 speaker amplifier IC. It can be used as a buzzer and also play high quality audio. Volume output is controlled via the potentiomet...

SKU: AF-5764 | Brand: Adafruit

The Adafruit TRRS Jack Breakout Board provides easy access to all four contacts of a 3.5mm TRRS (Tip-Ring-Ring-Sleeve) audio jack — commonly used for stereo audio plus a microphone channel, as found on mobile phone he...

SKU: AF-987 | Brand: Adafruit

This incredibly small stereo amplifier is surprisingly powerful - able to deliver 2 x 3.7W channels into 3 ohm impedance speakers. Inside the miniature chip is a class D controller, able to run from 2.7V-5.5VDC. Since...

SKU: DF-DFR1173 | Brand: DFRobot

This compact voice prompt module integrates an intelligent MP3 playback chip with a 1 W speaker in a tiny 30 × 11 mm package. It supports MP3, WAV, and WMA hardware decoding with 16 MB of on-board storage that retains...

SKU: DF-DFR0719 | Brand: DFRobot

A compact Bluetooth 5.0 audio receiver board that turns any wired speaker into a wireless one. Simply connect power (3.7–24V) and wire up your speaker — pair it with your phone and start streaming music wirelessly. Th...

SKU: DF-DFR0745 | Brand: DFRobot

Wanna buy a simple & practical voice recorder? This one is right for you! The voice recorder module supports 4 controlling modes (Arduino, AT command, on-board buttons, and ADKEY), and multi-segment voice recording. Y...

SKU: AF-3492 | Brand: Adafruit

The Adafruit PDM MEMS Microphone Breakout provides a digital audio input using Pulse Density Modulation (PDM) — a common interface in commercial products that's distinct from both analogue and I2S microphones. It's id...

SKU: AF-1788 | Brand: Adafruit

The Adafruit Music Maker MP3 Shield with 3W Stereo Amp turns any Arduino into a powerful audio player, recorder, and MIDI synthesiser — with built-in amplification for driving speakers directly. Powered by the VS1053B...

SKU: SF-SEN-14262 | Brand: SparkFun

The SparkFun Sound Detector is a small and very easy-to-use audio sensing board with three different outputs. The Sound Detector not only provides an audio output, but also a binary indication of the presence of sound...

SKU: SF-WIG-13660 | Brand: SparkFun

The WAV Trigger is a unique high-fidelity polyphonic audio player with surprising capabilities. Supporting up to 2048 uncompressed 16-bit, 44.1kHz wav files – the same quality as an audio CD – the WAV Trigger can p...

SKU: SF-DEV-13116 | Brand: SparkFun

The SparkFun Spectrum Shield splits a stereo audio input into 7 frequency bands per channel using two MSGEQ7 graphic equaliser ICs. Read the amplitude of each band via your Arduino's ADC to create sound-reactive proje...