Audio Processing Modules

SKU: DF-TEL0108 | Brand: DFRobot

This Bluetooth audio receiver module supports wireless streaming, USB flash drive, and TF (microSD) card playback. It decodes MP3, WMA, WAV, and lossless FLAC audio formats, with a built-in pre-amp output capable of d...

SKU: SF-DEV-20690 | Brand: SparkFun

The SparkFun Qwiic Speaker Amp includes the Texas Instruments TPA2016D2 stereo, filter-free class-D audio power amplifier. What distinguishes this audio amplifier from others is that it features volume control (i.e. g...

SKU: AF-1381 | Brand: Adafruit

This breakout board is the ultimate companion for the VLSI VS1053B DSP codec chip. The VS1053 can decode a wide variety of audio formats such as MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM). It can al...

SKU: DF-SEN0232 | Brand: DFRobot

The Gravity Analog Sound Level Meter is an Arduino-compatible decibel meter that accurately measures environmental noise levels. It uses an instrumentation-grade circuit with a low-noise microphone for high-precision ...

SKU: DF-DFR0126 | Brand: DFRobot

This Audio Analyzer module features the MSGEQ7 graphic equalizer display filter.It will give your arduino ears. Sound is broken down into seven frequency bands and the peak level for each band can be read. The seven ...

SKU: SF-COM-10468 | Brand: SparkFun

The MSGEQ7 is a CMOS graphic equaliser IC that divides the audio spectrum into seven frequency bands: 63 Hz, 160 Hz, 400 Hz, 1 kHz, 2.5 kHz, 6.25 kHz, and 16 kHz. Each band is peak-detected and multiplexed to provide ...

SKU: SF-SEN-12642 | Brand: SparkFun

The SparkFun Sound Detector is a small and very easy to use audio sensing board with three different outputs. The Sound Detector not only provides an audio output, but also a binary indication of the presence of so...

SKU: AF-3482 | Brand: Adafruit

This Panel Mount 10K Dual Logarithmic Potentiometer w/ On-Off Switch is a two-in-one; you get a dual-ganged potentiometer and an on-off switch. For the potentiometer-half, you've got a dual standard log-t...

SKU: AF-5954 | Brand: Adafruit

The Adafruit TRRS Trinkey is a USB-A plug-in microcontroller designed specifically for assistive technology. It combines an ATSAMD21 processor with a switched TRRS 3.5mm audio jack, connecting all 6 jack pins (tip, ri...

SKU: DF-DFR0805 | Brand: DFRobot

Make a subwoofer speaker with this bass & treble control Bluetooth Amplifier to enjoy the cinema-style acoustics in the home! Integrated with 3 output channels, this powerful Bluetooth Amplifier has AM interference an...

SKU: DF-DFR0782 | Brand: DFRobot

An evaluation board for a dual-mode Bluetooth 5.0 module that handles both wireless audio and serial data pass-through simultaneously. It can play audio from U-disk or TF card, stream audio over Bluetooth, handle Blue...

SKU: AF-4361 | Brand: Adafruit

Pipe audio in or out of your project with this very handy panel mount audio jack. It's a mono jack with a disconnect pin so you'll get a ground sleeve pin, a left tip pin and a pin that will be disconnected when a jac...

SKU: DF-DFR0498 | Brand: DFRobot

DFRobot FireBeetle series are low power consumption development modules designed for Internet of Things (IoT). The FireBeetle Covers-Camera & Audio Media Board is a multimedia device for IoT that provides interfac...

SKU: KI-46124 | Brand: Kitronik

The MonkMakes Speaker Board is a compact, amplified speaker designed for the BBC micro:bit. Simply connect it with crocodile clips and start adding sound to your micro:bit projects — despite its small size, the speake...

SKU: AF-1552 | Brand: Adafruit

This incredibly small stereo amplifier is surprisingly powerful - able to deliver 2 x 2.1W channels into 4 ohm impedance speakers (@ 10% THD). Inside the miniature chip is a class D controller, able to run from 2.7V-5...

SKU: SF-BOB-11044 | Brand: SparkFun

This tiny audio amplifier is based on the Texas Instruments TPA2005D1. Its efficient class-D operation means low heat and long battery life. It can drive an 8-Ohm speaker at up to 1.4 Watts; it won’t shake a stadium, ...

SKU: SF-DEV-11013 | Brand: SparkFun

The LilyPad MP3 Player is an all-in-one audio board combining an Arduino-compatible microcontroller, MP3 decoder, microSD card socket, and stereo amplifier. Part of the LilyPad e-textiles line, it's designed to add mu...

SKU: DF-FIT0404 | Brand: DFRobot

A 1-metre Y-cable that splits a 3.5 mm stereo signal into two RCA connectors, making it easy to connect phones, tablets, laptops, or media players to home audio systems, amplifiers, and receivers. Most portable devic...

SKU: AF-1799 | Brand: Adafruit

A solder-on 3.5 mm (1/8") TRRS plug for building custom audio cables. Made from durable metal with a flexible spring strain relief, it provides a solid, professional-quality connection. Solder your wires to the four c...

SKU: AF-1801 | Brand: Adafruit

A solder-on 3.5 mm (1/8") stereo audio jack for building custom audio cables and extensions. This is a free-hanging, in-line jack (not panel mount) — made from durable metal with a flexible spring strain relief to pro...