Audio Processing Modules

SKU: DF-SEN0487 | Brand: DFRobot

This tiny MEMS microphone has an amplifier gain of 66. When there is no sound detected, it outputs voltage around 0.66*VCC. When speaking, you can easily get the acoustic waveform by ADC sampling. The module can be us...

SKU: SS-101020023 | Brand: Seeed Studio

The Sound sensor module is a simple microphone. Based on the power amplifier LM386 and the electret microphone, it can be used to detect the sound strength of the environment. The value of output can be adjusted b...

SKU: DF-DFR0308 | Brand: DFRobot

The Arduino DTMF Shield is a dual-tone multi-frequency decoder module that lets your Arduino interpret touch-tone signals from phones. Connect it to a GSM/GPRS shield and you can send commands to your Arduino via phon...

SKU: AF-3885 | Brand: Adafruit

The Adafruit STEMMA Speaker combines a Class D audio amplifier with a 1W 8 Ω speaker in one slim, portable package. Connect ground, 3–5V power, and an audio signal via the JST-PH STEMMA connector or the alligator/sew-...

SKU: DF-DFR0699 | Brand: DFRobot

Gravity: I2C Voice Recorder Module EDU is DFRobot all-in-one voice interaction module, which integrates recording and playback functions into one. It can record with one button, and also supports Gravity: I2C interfac...

SKU: DF-DFR0760 | Brand: DFRobot

The Gravity Speech Synthesis Module converts text to spoken audio in English and Chinese, including mixed-language content. It connects via I2C or UART using the standard Gravity interface and includes a built-in spea...

SKU: DF-SEN0232 | Brand: DFRobot

The Gravity Analog Sound Level Meter is an Arduino-compatible decibel meter that accurately measures environmental noise levels. It uses an instrumentation-grade circuit with a low-noise microphone for high-precision ...

SKU: SF-COM-10468 | Brand: SparkFun

The MSGEQ7 is a CMOS graphic equaliser IC that divides the audio spectrum into seven frequency bands: 63 Hz, 160 Hz, 400 Hz, 1 kHz, 2.5 kHz, 6.25 kHz, and 16 kHz. Each band is peak-detected and multiplexed to provide ...

SKU: SF-SEN-12642 | Brand: SparkFun

The SparkFun Sound Detector is a small and very easy to use audio sensing board with three different outputs. The Sound Detector not only provides an audio output, but also a binary indication of the presence of so...

SKU: AF-5769 | Brand: Adafruit

The Adafruit Audio BFF is a compact add-on board that turns your QT Py or Xiao into a powerful audio playback device. It features a microSD card slot (up to 64 GB) and a MAX98357 I2S 3W amplifier, all designed to fit ...

SKU: AF-4361 | Brand: Adafruit

Pipe audio in or out of your project with this very handy panel mount audio jack. It's a mono jack with a disconnect pin so you'll get a ground sleeve pin, a left tip pin and a pin that will be disconnected when a jac...

SKU: KI-46124 | Brand: Kitronik

The MonkMakes Speaker Board is a compact, amplified speaker designed for the BBC micro:bit. Simply connect it with crocodile clips and start adding sound to your micro:bit projects — despite its small size, the speake...

SKU: SF-BOB-11044 | Brand: SparkFun

This tiny audio amplifier is based on the Texas Instruments TPA2005D1. Its efficient class-D operation means low heat and long battery life. It can drive an 8-Ohm speaker at up to 1.4 Watts; it won’t shake a stadium, ...

SKU: PI-ADP009 | Brand: Pimoroni

This nifty little USB dongle adds mono audio input and stereo output through USB (1.0). It's a cheap and cheerful solution for audio input to your Raspberry Pi. After testing a wide range of USB audio don...

SKU: AF-4181 | Brand: Adafruit

A 3.5 mm mono audio plug cable with alligator clips on the other end, making it easy to clip onto development boards like the BBC micro:bit or Adafruit Circuit Playground. Also compatible with AT (accessibility techno...

SKU: AF-4182 | Brand: Adafruit

A 3.5 mm mono audio jack cable with alligator clips on the other end, making it easy to clip onto development boards like the BBC micro:bit or Adafruit Circuit Playground. Also compatible with AT (accessibility techno...

SKU: SF-WIG-18159 | Brand: SparkFun

The Tsunami Super WAV Trigger is a polyphonic audio player built around an ARM Cortex M7, capable of mixing up to 32 mono or 18 stereo simultaneous uncompressed 44.1 kHz, 16-bit WAV tracks. Each track can be independe...

SKU: SF-BOB-28038 | Brand: SparkFun

A compact serial-controlled audio player breakout built around the MY1690X-16S decoder. Simply load MP3 or WAV files onto a microSD card, connect to your microcontroller via serial, and play audio with simple commands...

SKU: PR-PIM484 | Brand: Little Bird

Bring an old radio or set of speakers into the 21st century with Pirate Audio 3W Stereo Amp for Raspberry Pi! Get punchy digital audio through the push-fit terminals and control your music with the&nbsp...

SKU: PR-PIM261 | Brand: Little Bird

A complete internet radio project kit based on the Raspberry Pi Zero W. Includes a Pi Zero W, the pHAT BEAT DAC and stereo amplifier, a 5W speaker, and a retro-styled blue acrylic enclosure. Assembly takes approximate...