All Products

SKU: AF-4517 | Brand: Adafruit

The Adafruit LSM6DSOX + LIS3MDL is a precision 9 Degree of Freedom (9-DoF) inertial measurement unit on a single breakout board. It combines the LSM6DSOX accelerometer/gyroscope — known for exceptionally low gyro drif...

SKU: AF-5181 | Brand: Adafruit

The AM2301B is an affordable enclosed temperature and humidity sensor featuring an I2C interface — a modern upgrade over the classic DHT22/AM2302 sensors that required bit-bang timing protocols. Inside is the proven A...

SKU: AF-4570 | Brand: Adafruit

The Adafruit DS1841 is an I2C-controlled logarithmic digital potentiometer from Maxim with a resistance range of 3.7 kΩ to 22 kΩ across 128 tap points. Unlike linear potentiometers, the DS1841's logarithmic response c...

SKU: AF-3967 | Brand: Adafruit

The Adafruit VL53L1X (also known as VL53L1CX) is a next-generation Time-of-Flight (ToF) distance sensor from ST with an impressive 4-metre range and LIDAR-like precision. Using an invisible laser and matching sensor, ...

SKU: DF-SEN0497 | Brand: DFRobot

The DHT20 temperature & humidity sensor is the newly upgraded version of the DHT11. Data accuracy, stability, response speed, measurement range are greatly improved up. DHT20 is a brand new ASIC dedicated chip, an imp...

SKU: AF-4711 | Brand: Adafruit

The AP3429A Buck Converter Breakout steps down 3.4–5.5V input to a stable 3.3V output at up to 1.2A, with 90–95% efficiency. It's ideal for powering 3.3V circuits from LiPo batteries, 3× alkaline cells, or USB power s...

SKU: LB-TILT | Brand: Little Bird

A simple tilt sensor module that detects orientation changes. When tilted, the internal conductive ball breaks the circuit; when returned upright, it reconnects — providing a digital output signal. It's a compact, low...

SKU: LB-JSTBOARD | Brand: Little Bird

This E-textiles board is a breakout for a JST, so you can sew it onto a garment or use it in Paper Circuits! The JST breakout board can be easily sewn through the large holes. For paper circuits, simply apply coppe...

SKU: AF-4101 | Brand: Adafruit

The Adafruit MCP9600 I2C Thermocouple Amplifier handles all the analogue complexity of thermocouple measurement for you. Simply connect your thermocouple, wire up I2C, and read accurate temperature data from virtually...

SKU: AF-4162 | Brand: Adafruit

The Adafruit VEML7700 is a high-accuracy ambient light sensor from Vishay that outputs calibrated lux values over I2C. Unlike basic light sensors that return unitless brightness readings, the VEML7700 calculates lux (...

SKU: AF-1375 | Brand: Adafruit

This breakout board is the simplest way to create a project with a single "toggle" capacitive touch sensor. No microcontroller is required here - just power with 1.8 to 5.5VDC and touch the pad to activate the sens...

SKU: AF-3492 | Brand: Adafruit

The Adafruit PDM MEMS Microphone Breakout provides a digital audio input using Pulse Density Modulation (PDM) — a common interface in commercial products that's distinct from both analogue and I2S microphones. It's id...

SKU: SF-SEN-14262 | Brand: SparkFun

The SparkFun Sound Detector is a small and very easy-to-use audio sensing board with three different outputs. The Sound Detector not only provides an audio output, but also a binary indication of the presence of sound...

SKU: DF-DFR0028 | Brand: DFRobot

This is an arduino tilt sensor. It is used to detect orientation. Inside the sensor, there is a ball that make contact with the pins when the case is upright. Tilt the sensor over and the balls don't touch, thus n...

SKU: SF-SEN-13637 | Brand: SparkFun

A simple breakout board for measuring moisture in soil and similar materials. The two large exposed pads act as probes — functioning as a variable resistor where higher moisture means better conductivity, lower resist...

SKU: SF-BOB-12758 | Brand: SparkFun

The SparkFun Electret Microphone Breakout pairs a small electret microphone capsule with a 60× OPA344 op-amp preamplifier, making it easy to detect sound with a microcontroller's analogue-to-digital converter. Pick up...

SKU: AF-163 | Brand: Adafruit

A precision triple-axis accelerometer breakout featuring the Analog Devices ADXL335. With a ±3 g measurement range and analog outputs for X, Y, and Z axes, this sensor is ideal for tilt sensing, motion detection, and ...

SKU: DF-DFR0034 | Brand: DFRobot

This is a new Arduino compatible Analog Sound Sensor. Sound Sensor is typically used in detecting the loudness in ambient, the Arduino can collect its output signal and actuate accordingly. You may use it to make some...

SKU: AF-2857 | Brand: Adafruit

The Adafruit Sensirion SHT31-D is a high-accuracy temperature and humidity sensor with a true I2C interface and PTFE filter for protection against dust and contaminants. Part of Sensirion's third-generation SHT sensor...

SKU: DF-TEL0191 | Brand: DFRobot

The HUSKYLENS 2 WiFi Module is a plug-and-play USB expansion accessory that adds high-speed Wi-Fi 6 connectivity to the HUSKYLENS 2 AI vision sensor. Transform your HUSKYLENS 2 from a wired peripheral into a fully wir...