Adafruit

SKU: AF-1789 | Brand: Adafruit

This 1K potentiometer is a two-in-one, good in a breadboard or with a panel. Its a fairly standard linear taper 1K ohm potentiometer, with a grippy shaft. Its smooth and easy to turn, but not so loose that it will ...

SKU: AF-1792 | Brand: Adafruit

Add a little sparkle to your wearable project with Adafruit LED Sequins. These tiny sewable LED boards are the simpler sibling of Flora NeoPixels — they display a single colour with no digital control needed, making t...

SKU: AF-1863 | Brand: Adafruit

This switched JST connector is the best way to quickly prototype with our LiPoly batteries. We paired a genuine JST connector with a slide switch that can do up to 600mA. Both are soldered onto a breadboard-friendl...

SKU: AF-1875 | Brand: Adafruit

Because the Arduino (and Basic Stamp) are 5V devices, and most modern sensors, displays, flash cards and modes are 3.3V-only, many makers find that they need to perform level shifting/conversion to protect the 3.3V de...

SKU: AF-2222 | Brand: Adafruit

Connect your own PCB to a Raspberry Pi B+ with this normal-height female header.  The female header part is about 8.5mm tall, good for small HATs that do not to clear the USB/Ethernet jacks. This header has 3m...

SKU: AF-2201 | Brand: Adafruit

This is just about the cutest, tiniest little micro servo we could find, even smaller than the 9 gram micro servos we love so much.  It can rotate approximately 180 degrees (90 in each direction) and works just l...

SKU: AF-2187 | Brand: Adafruit

A custom-made 2×20 short female header designed for surface-mount (SMT) Raspberry Pi HAT designs. This header provides the slimmest possible profile when you need a low-clearance connection between your HAT and a Rasp...

SKU: AF-2168 | Brand: Adafruit

Infrared (IR) break-beam sensors are a simple way to detect motion. They work by having an emitter side that sends out a beam of human-invisible IR light, then a receiver across the way which is sensitive to that s...

SKU: AF-2343 | Brand: Adafruit

These APA102C (DotStar) RGB LEDs feature an integrated driver chip inside each 5050 SMD package, giving you individually addressable 24-bit colour control (8 bits each for red, green, and blue). The same smart LED use...

SKU: AF-2350 | Brand: Adafruit

These APA102 (DotStar) warm white LEDs feature an integrated driver chip inside each 5050 SMD package, giving you individually addressable brightness control over three warm white (~3000K) dies. The phosphor coating p...

SKU: AF-2337 | Brand: Adafruit

Finally we get our very own super sweet sixteen... 16 millimeters that is! Our Black Plated M/F Brass 16mm Standoffs are engineered specifically to keep your PiTFT or other Pi accessories w...

SKU: AF-2424 | Brand: Adafruit

This stepper motor is a little different than the large NEMA-17 types you may be used to. These are often used in gauges for motorcycles and cars to replace the old-style fully-analog type. They have extremely fine...

SKU: AF-2476 | Brand: Adafruit

Replacement silicone tubes for the Professional Silicone-Tip Solder Sucker. Cut to your desired length as needed — the elastic, heat-resistant silicone withstands temperatures up to 350°C, letting you get close to you...

SKU: AF-2473 | Brand: Adafruit

A 50 g spool of lead-free solder wire ideal for through-hole and surface-mount soldering. With a 0.5 mm diameter and no-clean rosin flux core, this wire delivers clean, reliable joints without the need for post-solder...

SKU: AF-2822 | Brand: Adafruit

If we could eat headers, we'd have them for breakfast, lunch, and dinner.  But we can't :( So we're making the best of it and selling them! This 2x20-pin strip male header is a great way to a...

SKU: AF-2897 | Brand: Adafruit

A simple adapter that sits inside a 5.5 / 2.5 mm DC barrel jack, allowing you to use a standard 5.5 / 2.1 mm barrel plug with it. Just insert the adapter into the device's 2.5 mm jack, then plug in your 2.1 mm power s...

SKU: AF-184 | Brand: Adafruit

Build your own breadboard-friendly adjustable power supply with this soldering kit. Based on the MIC2941 low-dropout regulator, it provides a guaranteed 1.25A output with only 40–400 mV dropout — far better than the L...

SKU: AF-377 | Brand: Adafruit

This high-quality 24-pulse rotary encoder features detented rotation with a satisfying click at each step, a built-in push-button switch, and a panel-mount design. It comes with a soft-touch knob with an arrow indicat...

SKU: AF-2765 | Brand: Adafruit

The Mini 2-Axis Analog Thumbstick is a compact, self-centring joystick with a black rocker cap, similar in style to PSP joysticks. It provides smooth directional analogue input using two 10 kΩ potentiometers — one for...

SKU: AF-3258 | Brand: Adafruit

Check out this handy MicroUSB extension cable, which will make it easy for you to enclose a device that has a B type (micro USB host) port. Great if you need to extend the USB port for your Raspberry Pi, Arduino,...