All Products

SKU: SF-DEV-18425

The MyoWare 2.0 Link Shield connects a MyoWare 2.0 Muscle Sensor to your Arduino microcontroller via a 3.5mm TRS cable. Simply snap the Link Shield onto your Muscle Sensor using the built-in snap connectors, connect a TRS-to-TRS cable, and link it to the MyoWare 2.0 Arduino Shield on your develop...

SKU: DF-SEN0276

The MB1009 ParkSonar-EZ-144 is an ultrasonic proximity and range sensor from MaxBotix, designed to detect vehicles within a calibrated detection zone. It reports when a target enters or leaves the zone, with both proximity and range data available via logic-level (high/low) and RS232 serial outpu...

SKU: EC-MCS02930M

This Adruino compatible motor Driver shield is a full-featured products that it can be used to drive 4 DC motor or two 4-wire stepper and two 5v servo. It drive the DC motor and stepper with the L293D,and it drive the servo with arduino pin9 and pin10. Features Be able to drive 4 DC motor and...

SKU: DF-DRI0027

Some day,a guy want to make a robotic dog as a gift to his little son.He brought some digital servos, a microcontroller,Lipo batterys...Then he found it hard to drive these smart servos with Arduino processor! So we developed a driver board that can easily & quickly drive the digital servo...

SKU: WS-29380 · MPN: 29380

This 0.71″ round LCD module packs a 160 × 160 pixel IPS display with 65K colours into a tiny 20 × 22 mm footprint. Driven by the GC9D01 controller over a 4-wire SPI interface, it's easy to integrate with Raspberry Pi Pico, ESP32, Arduino, and other microcontrollers using minimal IO pins. The rou...

SKU: EC-ACS53201S

NFC(Near Field Communication) is a set of standards for smartphones and similar devices to establish radio communication with each other by touching them together or bringing them into close proximity , it builds upon RFID systems by allowing two-way communication between endpoints. Compared with...