Audio Processing Modules

SKU: DF-DFR1173 | Brand: DFRobot

This compact voice prompt module integrates an intelligent MP3 playback chip with a 1 W speaker in a tiny 30 × 11 mm package. It supports MP3, WAV, and WMA hardware decoding with 16 MB of on-board storage that retains...

SKU: DF-DFR0719 | Brand: DFRobot

A compact Bluetooth 5.0 audio receiver board that turns any wired speaker into a wireless one. Simply connect power (3.7–24V) and wire up your speaker — pair it with your phone and start streaming music wirelessly. Th...

SKU: DF-DFR0745 | Brand: DFRobot

Wanna buy a simple & practical voice recorder? This one is right for you! The voice recorder module supports 4 controlling modes (Arduino, AT command, on-board buttons, and ADKEY), and multi-segment voice recording. Y...

SKU: EC-ASVS1053MP | Brand: Elecrow

An Arduino-compatible MP3 shield based on the VS1053B audio codec from VLSI. It decodes all major audio formats — including MP3, OGG Vorbis, AAC, WMA, FLAC, WAV, and MIDI — and can record in Ogg Vorbis, IMA ADPCM, and...

SKU: AF-3492 | Brand: Adafruit

The Adafruit PDM MEMS Microphone Breakout provides a digital audio input using Pulse Density Modulation (PDM) — a common interface in commercial products that's distinct from both analogue and I2S microphones. It's id...

SKU: SF-SEN-14262 | Brand: SparkFun

The SparkFun Sound Detector is a small and very easy-to-use audio sensing board with three different outputs. The Sound Detector not only provides an audio output, but also a binary indication of the presence of sound...

SKU: SF-WIG-13660 | Brand: SparkFun

The WAV Trigger is a unique high-fidelity polyphonic audio player with surprising capabilities. Supporting up to 2048 uncompressed 16-bit, 44.1kHz wav files – the same quality as an audio CD – the WAV Trigger can p...

SKU: SF-DEV-13116 | Brand: SparkFun

The SparkFun Spectrum Shield splits a stereo audio input into 7 frequency bands per channel using two MSGEQ7 graphic equaliser ICs. Read the amplitude of each band via your Arduino's ADC to create sound-reactive proje...

SKU: SF-DEV-12898 | Brand: SparkFun

The SparkFun MIDI Shield board gives your Arduino-based device access to the antiquated, but still widely used and well supported MIDI communication protocol, so you can control synthesizers, sequencers, and other ...

SKU: DF-DFR0034 | Brand: DFRobot

This is a new Arduino compatible Analog Sound Sensor. Sound Sensor is typically used in detecting the loudness in ambient, the Arduino can collect its output signal and actuate accordingly. You may use it to make some...

SKU: AF-6251 | Brand: Adafruit

The Adafruit PCM5100 I2S DAC converts digital I2S audio into clean, high-quality stereo line-level output through a 3.5mm jack. With 100dB signal-to-noise ratio and no MCLK or I2C configuration required, simply pipe I...

SKU: AF-5647 | Brand: Adafruit

The Adafruit STEMMA Audio Amp is a compact mono Class D amplifier based on the PAM8302 chip, delivering up to 2.5W into 4 Ω speakers from a 2.0–5.5V DC supply. With over 90% efficiency at half a watt into 8 Ω, it's id...

SKU: AF-5770 | Brand: Adafruit

The Adafruit I2S Amplifier BFF is a compact add-on that brings high-quality 3W audio to any QT Py or Xiao development board. Featuring a MAX98357 Class D amplifier, it delivers crisp I2S digital audio using just three...

SKU: DF-SEN0327 | Brand: DFRobot

A compact digital MEMS microphone module based on the MSM261S4030H0 chip, providing 24-bit I2S digital audio output. The built-in I2S interface connects directly to DSPs and microcontrollers without requiring an exter...

SKU: AF-4181 | Brand: Adafruit

A 3.5 mm mono audio plug cable with alligator clips on the other end, making it easy to clip onto development boards like the BBC micro:bit or Adafruit Circuit Playground. Also compatible with AT (accessibility techno...

SKU: PR-PIM356 | Brand: Little Bird

Make your micro:bit sing with noise:bit! It's a tiny speaker that packs a fair bit of punch, and it's perfect for BLEEPS and BLOOPS! Just slot in your micro:bit, and use the sound generation blo...

SKU: AF-1790 | Brand: Adafruit

The Adafruit Music Maker MP3 Shield turns any Arduino into a versatile audio player, recorder, and MIDI synthesiser. Powered by the VS1053B codec chip, it decodes MP3, AAC, Ogg Vorbis, WMA, FLAC, WAV, and MIDI formats...

SKU: AF-2210 | Brand: Adafruit

The Adafruit Audio FX Sound Board with 2×2W Amp is a standalone audio trigger with a built-in stereo Class D amplifier — no Arduino or programming required. Simply drag and drop WAV or OGG sound files over USB, wire u...

SKU: AF-2790 | Brand: Adafruit

A 3.5 mm (1/8") stereo (TRS) audio plug with screw terminal connections — no soldering required. Use stranded or solid-core wire and a small screwdriver to create custom audio cables, breakouts, and test leads. This ...

SKU: AF-2915 | Brand: Adafruit

A 3.5 mm (1/8") 4-pole TRRS audio jack with screw terminal connections — no soldering required. Use stranded or solid-core wire and a small screwdriver to create custom audio wiring jigs, breakouts, and test setups. ...