This servo rotates fully forward or backwards instead of moving to a position. You can use any servo code, hardware or library to control these servos. Good for making simple moving robots. Comes with four different horns, as shown.
To control with an Arduino, they suggest connecting the control wire to pin 9 or 10 and using the Servo library included with the Arduino IDE (see here for an example sketch). Position "90" (1.5ms pulse) is stop, "180" (2ms pulse) is full speed forward, "0" (1ms pulse) is full speed backwards. They may require some simple calibration, simply tell the servo to 'stop' and then gently adjust the potentiometer in the recessed hole with a small screwdriver until the servo stops moving.
- Operating Voltage: 4.8V~6V (5V works best)
- Average Speed: ~0.18sec/60°
- Stall Torque (4.8V): 3kg.cm/41.74oz.in
- Stall Torque (6V): 3.2kg.com/44.52oz.in
- Required Pulse: 500us-2500us
- Connector Wire Length: 30cm / 11.8"
- Dimensions: 37mm x 54mm x 20mm / 1.5" x 2.1" x 0.8"
- Weight (no horns): 40g
- Spline Count: 25
- As of Friday, May 8th, 2015 they're selling a revised FeeTech version with additional horns!
- Adafruit 8-Channel PWM or Servo FeatherWing
- Adafruit 16-Channel PWM/Servo HAT for Raspberry Pi
- Adafruit Motor Selection Guide
- Modifying Servos for Continuous Rotation
- Adafruit Motor Shield V2 for Arduino
- LSM303 Accelerometer + Compass Breakout
- Adafruit 16-Channel Servo Driver with Arduino
- Adafruit 16 Channel Servo Driver with Raspberry Pi