Adafruit

SKU: AF-1381 | Brand: Adafruit

This breakout board is the ultimate companion for the VLSI VS1053B DSP codec chip. The VS1053 can decode a wide variety of audio formats such as MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM). It can al...

SKU: AF-1849 | Brand: Adafruit

Get started with wearable electronics using the Adafruit Gemma Sensor Starter Pack. This all-in-one kit includes a GEMMA V2 board, sewable RGB NeoPixels, multiple sensors, a rechargeable battery with charger, and ever...

SKU: AF-2378 | Brand: Adafruit

The Arduino Pro Mini is SparkFun's minimal design approach to Arduino.  It's essentially a 5v Arduino that runs an 16 MHz bootloader on a super small, super thin board.  There are no connectors attached -...

SKU: AF-2524 | Brand: Adafruit

This high-power RGB LED from Adafruit delivers serious brightness, with each red, green, and blue die capable of handling 350–750mA continuous current (2A peak). At 3W it produces approximately 150 lumens, scaling up ...

SKU: AF-2771 | Brand: Adafruit

The Feather 32u4 Basic Proto is the no-frills member of the Feather 32u4 family, with a built-in prototyping area where you can solder on extra components like buttons, sensors, or connectors without needing a separat...

SKU: AF-3000 | Brand: Adafruit

Would you like to learn electronics, with an all-in-one board that has sensors and LEDs built in? Circuit Playground is here - and it's the best way to practice programming on real hardware with no soldering or sew...

SKU: AF-178 | Brand: Adafruit

A 100 mm linear soft potentiometer (ribbon sensor) manufactured by Spectra Symbol. This pressure-sensitive ribbon controller features an adhesive backing for easy mounting and provides a variable resistance output bas...

SKU: AF-182 | Brand: Adafruit

This sensor can detect flexing or bending in one direction. They were popularized by being used in the Nintendo PowerGlove as a gaming interface.These sensors are easy to use, they are basically resistors that change ...

SKU: AF-334 | Brand: Adafruit

If you've got a resistive touch screen that you'd like to use, you'll need this breakout! It has a fine pitch (0.5mm) connector soldered onto it and it's broken out into the 4 resistive wires of the panel. A petite...

SKU: AF-3246 | Brand: Adafruit

A neat little breakout board designed for mounting a PSP-style mini thumbstick to your project. The board features panel-mount friendly hole placement and dual-sided headers for mechanical stability when connected to ...

SKU: AF-444 | Brand: Adafruit

Add a tiny joystick to your project with this PSP thumbstick. This is a replacement component for PSP1000's, but we think they'd make for a great little joystick/thumbstick add-on for a wearable, or portable pro...

SKU: AF-576 | Brand: Adafruit

Put a temperature meter anywhere with this very handy display. This panel meter displays the temperature of the attached waterproof 1% thermistor in °C. It does require a DC voltage to run, at 4.5-30VDC. It has revers...

SKU: AF-1918 | Brand: Adafruit

An analog UV light sensor breakout based on the GUVA-S12SD photodiode, detecting the 240–370nm range covering UVB and most of the UVA spectrum. An on-board op-amp amplifies the tiny photodiode current to a readable vo...

SKU: AF-3391 | Brand: Adafruit

This potentiometer is a two-in-one, good in a breadboard or with a panel. It's a log taper 10K ohm potentiometer, with a grippy shaft. It's smooth and easy to turn, but not so loose that it will shift on its own...

SKU: AF-3482 | Brand: Adafruit

This Panel Mount 10K Dual Logarithmic Potentiometer w/ On-Off Switch is a two-in-one; you get a dual-ganged potentiometer and an on-off switch. For the potentiometer-half, you've got a dual standard log-t...

SKU: AF-333 | Brand: Adafruit

A 4-wire resistive touch screen digitiser (originally designed for the Nintendo DS Lite) that works with a stylus or fingertip. It can be used with any microcontroller that has 2 digital pins and 2 analogue input pins...

SKU: AF-6267 | Brand: Adafruit

The Adafruit Metro RP2350 with PSRAM upgrades the Metro RP2350 with an additional 8 MB of QSPI PSRAM for projects that need extra dynamic memory. Powered by the Raspberry Pi RP2350 dual-core ARM Cortex-M33 at 150 MHz ...

SKU: AF-6167 | Brand: Adafruit

The Adafruit Sparkle Motion with wFL External Antenna is the flagship WLED smart LED driver with support for an external Wi-Fi antenna via a wFL connector. It offers the same full feature set as the standard Sparkle M...

SKU: AF-6160 | Brand: Adafruit

Adafruit Sparkle Motion Mini – Compact WLED Smart LED DriverThe Adafruit Sparkle Motion Mini is a streamlined version of our Sparkle Motion series, designed to be the smallest and most powerful WLED-friendly LED drive...

SKU: AF-6003 | Brand: Adafruit

The Adafruit Metro RP2350 brings the next-generation Raspberry Pi RP2350 dual-core processor to the standard Metro/UNO shield-compatible form factor. With dual ARM Cortex-M33 cores running at 150 MHz, 528 KB SRAM, 16 ...