Adafruit Power

Pimoroni OnOff SHIM for Raspberry Pi [AF-3581]

Get it by Wednesday, Dec 13th

Add a tiny yet convenient power switch to your Pi with Pimoroni's On-Off SHIM!Pimoroni's SHIMs (Shove Hardware in the Middle) are a new range of boards designed to be small, affordable, and handy. They're just 0.8mm thick (the bare board...

Pimoroni Button SHIM for Raspberry Pi [AF-3582]

Get it by Wednesday, Dec 13th

Pimoroni's Button SHIM gives you five handy, physical buttons and an RGB status LED, and it's HAT and pHAT-compatible!Pimoroni's SHIM-format boards are designed to slip neatly onto your Pi's GPIO pins and still allow you to use HATs an...

4-JSTPH 6 [AF-3568]

Get it by Wednesday, Dec 13th

This 4-wire cable is a little over 150mm / 6" long and fitted with JST-PH female 4-pin connectors on each end. These types of JST cables are commonly found on small rechargeable battery packs, RC receivers and transmitters, tiny camera...

Controllable Four Outlet Power Relay Module [(Power Switch Tail Alternative)] [AF-2935]

Say goodbye to hazardous high voltage wiring and create the Internet of Things with safe, reliable power control. The IoT Power Relay from Digital Loggers is custom designed to fit your every need when developing projects with Raspberr...

Alkaline AA batteries (LR6) - 3 pack [AF-3521]

Get it by Wednesday, Dec 13th

Battery power for your portable project! These batteries are good quality at a good price, and work fantastic with any of the kits or projects in the shop that use AAs. This is a pack of 3 AA batteries.These batteries are Alkaline (MnO...

Alkaline AAA batteries - 3 pack [AF-3520]

Get it by Wednesday, Dec 13th

Battery power for your portable project! These batteries are good quality at a good price, and work fantastic with any of the kits or projects in the shop that use AAA's. This is a pack of 3 AAA batteries.These batteries are Alkaline (...

5 x AA Battery Holder with 2.1mm DC Jack [AF-3456]

Get it by Wednesday, Dec 13th

Here's yet another addition to our family of AA battery holders. It's a holder for five (5) AA batteries, with 5" wire leads. It's black and has a 2.1mm barrel plug (tip positive).5 x AA battery packs are best used with Arduino-compati...

USB Micro B Cable with Data/Charge Sync Switch [AF-3439]

Get it by Wednesday, Dec 13th

Your cell phone charges off of USB, but can you really trust that charging station at the airport? Now you can control when to allow data in or out of your device with this little USB extension cable. It can be used with any device tha...

USB Extension Cable with Data/Charge Sync Switch [AF-3438]

Get it by Wednesday, Dec 13th

Your cell phone charges off of USB, but can you really trust that charging station at the airport? Now you can control when to allow data in or out of your device with this little USB extension cable. You can plug it onto the end of an...

Reset / Enable Controller - KA75330 3.3V Voltage Detector [AF-3428]

Get it by Wednesday, Dec 13th

A voltage detector is handy for projects where you want to make sure your microcontroller doesn't run at a low voltage. For example, say you have a Feather Huzzah running on a lipoly battery every few minutes. Eventually the battery ru...